Note: Using the Easy-start feature beyond the initial ramp-up period is not
recommended and reduces Sonicare’s effectiveness in removing plaque.
Cleaning
Do not clean brush heads, handle, charger, charger cover or replaceable
panels in the dishwasher.
Toothbrush handle
1 Remove the brush head and rinse the metal shaft area with warm
water (Fig. 10).
Do not push on the rubber seal on the metal shaft with sharp objects,
as this may cause damage.
2 Use a damp cloth to wipe the entire surface of the handle.
Brush head
1 Rinse the brush head and bristles after each use (Fig. 11).
2 Remove the brush head from the handle and rinse the brush head
connection at least once a week with warm water.
Charger
1 Unplug the charger before cleaning.
2 Use a damp cloth to wipe the surface of the charger.
Storage
- If you are not going to use the Sonicare for an extended period of
time, unplug the charger from the electrical outlet, clean it and store
it in a cool and dry place away from direct sunlight.
Replacement
Brush head
- Replace Sonicare brush heads every 3 months to achieve optimal
results.
- Use only Sonicare For Kids replacement brush heads.
Disposal
- The rechargeable battery inside your Sonicare cannot be replaced,
but it is easy to remove for recycling. At the end of the toothbrush’s
life and prior to disposal, please remove the rechargeable battery
from the handle by following the instructions below.
- Do not throw away the appliance with the normal household
waste at the end of its life, but hand it in at an ofcial collection
point for recycling. By doing this, you help to preserve the
environment (Fig. 12).
- The built-in rechargeable battery contains substances that may pollute
the environment. Always remove the battery before you discard the
appliance, and recycle or dispose of the battery according to local
waste management requirements.
- If you have any recycling questions, contact your local waste
management ofce.
Removing the rechargeable battery
Please note that this process is not reversible.
- To remove the rechargeable battery, you need a at-head (standard)
screwdriver. Observe basic safety precautions when you follow the
procedure outlined below. Be sure to protect your eyes, hands,
ngers, and the surface on which you work.
1 To deplete the rechargeable battery of any charge, remove the
handle from the charger, turn on the Sonicare and let it run until it
stops. Repeat this step until you can no longer turn on the Sonicare.
2 Insert a screwdriver into the slot located in the bottom of the
handle and turn counterclockwise until you see a gap between the
bottom cap and the handle (Fig. 13).
3 Insert the screwdriver into the gap and pry the bottom cap out of
the handle (Fig. 14).
4 Hold the handle upside down and push down on the shaft to release
the internal components of the handle (Fig. 15).
5 Insert the screwdriver under the circuit board, next to the battery
connections, and twist to break the connections. Remove the
circuit board and pry the battery from the plastic carrier (Fig. 16).
The rechargeable battery can now be recycled or disposed of and the
rest of the product discarded appropriately.
Using the Sonicare For Kids
Brushing instructions
For children under age 8, it is recommended that a parent or adult
caregiver perform tooth brushing.
1 Wet the bristles and apply a small amount of toothpaste.
2 Place the toothbrush bristles against the teeth at a slight angle
towards the gumline (Fig. 6).
3 Press the power on/off button to turn on the Sonicare.
4 Apply light pressure to maximize Sonicare’s effectiveness and let
the Sonicare toothbrush do the brushing for you.
5 Gently move the brush head slowly across the teeth in a small back
and forth motion so the longer bristles reach between the teeth.
Continue this motion throughout the brushing cycle.
Note: To make sure you brush evenly throughout the mouth, divide the mouth
into 4 sections using the KidPacer feature (see chapter “Features”).
6 Begin brushing in section 1 (outside top teeth) a series of musical
notes indicate it is time to move to section 2 (inside top teeth). At
the next series of notes move to section 3 (outside bottom teeth).
The next series of notes indicate it is time to move to section 4
(inside bottom teeth). The toothbrush will automatically turn off
at end of the brushing cycle (Fig. 7).
7 After you have completed the brushing cycle, you can spend
additional time brushing the chewing surfaces of your teeth and
areas where staining occurs. You may also brush your tongue,
with the toothbrush turned on or off, as you prefer (Fig. 8).
Your Sonicare is safe to use on:
- Braces (brush heads wear out sooner when used on braces)
- Dental restorations (llings, crowns, veneers)
Brushing modes
The toothbrush automatically starts in the default high mode.
1 Press the brushing mode button to toggle between modes (Fig. 9).
, The green mode light indicates the selected mode.
- High mode: Full-strength mode designed for older/independent
brushers.
- Low mode: Reduced power mode used for training and introducing
younger children to the sonic experience.
Features
KidTimer
- The KidTimer plays a congratulatory sound sequence at the end
of the pre-determined brushing time. Additionally, the KidTimer
automatically turns off the handle when the brushing cycle is
complete.
- When in high mode, the KidTimer is set at 2 minutes.
- When in low mode the KidTimer is set at 1 minute and slowly
increases over time. The progression of time helps young children
reach the dentist recommended 2 minutes of brushing.
Note: Instruct your child to brush until they hear the congratulatory tune and
the toothbrush turns off.
KidPacer
The KidPacer uses a short series of tones to alert the brusher to move to
the next brushing quadrant of the mouth. This ensures that the child gets
a thorough, overall clean (see “Brushing instructions”).
Easy-start
- The Sonicare For Kids comes with the Easy-start feature activated.
- The Easy-start feature gently increases the power over the rst
14 brushings.
Note: Each of the rst 14 brushings must be at least 1 minute in length to
properly advance through the Easy-start ramp-up cycle.
Deactivating or activating the Easy-start feature
1 Attach the brush head to the handle.
2 Place the handle in the plugged-in charger.
- To deactivate Easy-start:
Press and hold the power on/off button for 2 seconds. You hear 1 beep
to indicate that the Easy-start feature has been deactivated.
- To activate Easy-start:
Press and hold the power on/off button for 2 seconds. You hear 2 beeps
to indicate that the Easy-start feature has been activated.
