Models
3102-60, 3102-78,
3102-105, 3102-118
&
3102-Custom
Block Filter
© 2001
, Channel Vision™
234 FISCHER AVENUE l COSTA MESA, CA 92626
(714) 424-6500 l (800) 840-0288 l (714) 424-6510 FAX
HTTP://WWW.CHANNELVISION.COM l E-MAIL: SALES@CHANNELVISION.
COM
Channel Vision’s block filters are used to pass all lower
channels below cable channels below 60, 78, 105,
118 or a
channel of your choice and block (clean up) frequencies above
that channel. Use these filters to remove unwanted cable
company or interfer ence. These filters will provide the best
quality picture on the channel you wish to modulate. Prevent
a callback by using a low pass filter on every installation.
Custom frequencies available upon request.
Filter Description:
C
hannel Vision Technology is a manufacturer of video di
s-
tri
bution components, with over 240 products
including convenience, peace
-of-mind, and improved qua l-
ity of life. Product line includes: broad line of RF modul
a-
tors with stereo audio for multi
-room video
distribution, phone
-
line entry systems, B&W and color su
r-
veillance cameras, flush mount cameras, modular RF and
Cat 5 distribution panels for structured wiring and home
theater distribu tion of surround sound audio to multiple
zones.
Step 1:
Look at selected channel prior to inserting
filter into the system.
Step 2:
Connect the filter on the incoming cable line
prior
to amplification or modulator combiner.
Note: See installation diagram below.
Step 3:
Look at selec
ted channel to verify picture is clean
snow, without any lines or interference at four
channels beyond the filter channel.
IE: 3102-78
would be clean after channel 82.
Step 4:
Insert modulator into the system and check
Instructions:
CVT Modulator
HS-2
3102 Filter
Cable Company
Signal
Channel Vision
Limited Warranty
Channel Vision Technology will repair or replace any defect in
material or workmanship which occur during normal use of this
product with new or rebuilt parts, free of charge in the USA, for
two years from the date of original purchase. This warranty
does not cover damages in shipment, failures caused by other
products not supplied by Channel Vision Technology, or
failures due to accident, misuse, abuse, or alteration of the
equipment. This warranty extends only to the original
purchaser.
A purchase receipt, invoice, or other proof of original purchase
date will be required before warranty repairs are provided.
Mail in service can be obtained during the warranty period by
calling (714) 424-6500. A Return Authorization number must
be obtained in advance and be marked on the outside of the
shipping carton.
This warranty gives you specific legal rights, and you may have
other rights (which vary from state to state). If a problem with
this product develops during or after the warranty period,
please contact Channel Vision, your dealer, or any factory-
authorized service center.
/
