Well Cover Installation Instructions

1. Place window well cover over well.

2. Mark position of holes for clips on center of well

rim with a marker on the window well cover. Two

(2) clips on each side and one (1) clip on the front

of the well.

3. Remove window well cover and drill a 3/16” hole at

each marked location on window well cover. Do not

drill window well cover when cold, window well cover

Shape Products, LLC warrants it’s Egress Window Well Covers for a period of seven (7) years from the dated of purchase. This warranty only extends to the original purchaser.

This warranty does not apply to damage from accident, misuse, normal wear, alteration, improper installation, improper maintenance, abuse or excessive weather damage. Any

implied warranties which the purchaser may have are limited in duration to seven (7) years from the date of purchase. Some states do not allow limitation on how long any

implied warranty lasts, so the above limitations will not apply in those states. Shape Products, LLC. will replace a window well cover with a manufacturer’s defect free of charge,

(except for dealer labor and shipping). Contact Shape Products, LLC. Via phone or email listed below ( or see your Shape Products, LLC. dealer) to obtain service under this

warranty. Note proof of purchase and pictures of damage is required, and replacement is the sole remedy of purchaser under this warranty. Shape Products, LLC. will assess

proof to determine whether a replacement is warranted. In no event shall Shape Products, LLC. be liable for any incidental or consequential damages, losses, or expenses. Some

Cap Nut

Adjust spring clips by loosening or tightening cap nuts.

6. If your window projects above the window well,