Master DH water-pump kit Owner's manual

Brand: Master

Model: DH water-pump kit

Type: Owner's manual

DH Series -

Water pump kit Instruction Manual

1. Components List

No.

Item

Qty

Material

Remark

1

Carton

1

295*202*176mm

2

Foam

1

3

EPE

1

294*196*10mm

4

Bracket set

1

Not for DH772

4-1

Bracket

1

Cold-rolled sheet/δ1.5

4-2

Hose support

1

ABS

4-3

Condensate hose

1

PVC φ20×φ16

160mm

5

Water-pump

1

MEC-20，220V/50/60Hz

6

Inner box

1

212*163*61mm

7

Hoop (MEC)

1

Galvanized plate / δ1.0

31

8

Ziplock bag

1

40*60*0.08mm

For screws

9

M4×12 screw

6

10

Drain hose

1

PVC φ14×φ10

3m

11

4

Nylon 66

HDS-120M/3×120

Wiring String

2. Instructions:

Main Box:

Inner box:

3. Installation

The factory standard of this series of dehumidifiers is water-tank type. If water tank and

water pump are selected, the specific replacement steps are as follows:

Attention - Power off before replacement work!!!

a. Remove the tank.

As shown in figure (1):

b. Pull off the press-pin on the infrared switch on the tank and three-core male socket.

As shown in figure (2):

c. Remove the press-pin.

As shown in figure (3) :

Please note: Not available for DH772!

d. Open the pump accessories box, and take out the pump, pump hoop, bracket, water

socket & condensate hose (Inner-diameter - 16), drain hose (inner diameter 10), binding

belt, screw, etc.

e. Put the water pump under the dip-tray and fix the water pump on the middle support plate

and water-tank base plate with the pump hoop and screws.

As shown in figure (5):

f. Fix

the bracket + water base + water connection pipe with screws on the water tank

backing plate (6), and put the connection pipe into the water pump connection mouth

As shown in figure (6) & (7):

Note: DH772 is not available for figure (6). Instead, the connecting pipe is directly inserted

into the outlet of the water tray and tied with strip firmly.

g. Then insert the drain pipe into the drain port of the water pump and tie it securely with a

binding belt.

As shown in figure:

h. Insert the male head of the three-core socket into the female head of the three-core

socket. Insert the male head of the five-core socket into the female head of the five-core

socket.

As shown in figure (9):

4. How to Use

After installation is completed, close water-tank door, then power on the unit after the drain

hose is settled.

There are no more other adjustments required.

5. Maintenance

This water-pump kit does not require special maintenance.

Keep water-tank kit well-stored for next use.

1
2
3
4
5
6
7

Master DH water-pump kit Owner's manual

Brand: Master

Model: DH water-pump kit

Type: Owner's manual

Download PDF

Other documents