LARSON R97 Installation guide

Type
Installation guide

This manual is also suitable for

Comfort Bilt® Rollup Garage Screen
Thank you for your purchase of the Comfort Bilt® Rollup Garage Screen. Our screen is available in 2 sizes and will
fit a single or double garage door up to 7’ high. The installation instructions are simple and can be used to install
either size.
Items Included
Screen unit with female snaps
Male snaps & screws
Tools Needed
#2 Phillips screw driver
...or bit for a cordless drill
Tape Measure
Pencil
Step ladder
Installation Steps
1. Measure the width of your opening and mark the center of the surface where the screen will be attached
2. Install one male snap with the screws provided
3. Attach the center female snap of the screen unit to the male snap you installed
4. Stretch the screen left or right from the center snap and mark the location for the next male snap and install
5. Attach the corresponding female snap and continue to stretch, mark and install each of the remaining snaps around
the opening.
Operation
The screen can be stored up as needed by unzipping the center and rolling the screen to the top of your opening.
The rolled up screen is held in place by the buckles attached to the screen
Tips & Comments
Be sure to stretch the screen enough to get a snug fit but remain slightly relaxed to reduce stress on the snaps
The use of a PVC pipe (not included) may allow easier rolling and storage of the screen in the opening
Install center snap first
Stretch, mark & install remaining snaps
R97, R167
202220899-1015
  • Page 1 1

LARSON R97 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI