Dock Edge DE90302F Operating instructions

INSTALLATION INSTRUCTIONS

DE90302F Mooring Snubber

Mooring snubber

9.5-11 mm (3/8” - 7/16”)

Tensile strength test:

300 New Huntington Road, Woodbridge, ON

Canada, L4H 0R4 www.dockedge.com

Thread the cord through the holes and draw the snubber to the required

position on the cord. If necessary apply soap to ease the ﬁtting.

For secure and cushioned mooring of smaller

boats up to 6m (20ft) in length, and designed

for a line diameter of 9.5-11mm (3/8”- 7/16”).

The snubber is tested with a 11mm (7/16”) line with 3

turns of winding. The graph shows the extension in

comparison to the load.

The forces the line is exposed for, is taken up by the

elongation of the mooring snubber. A large elongation

reduces the load on the line and the boat’s brackets.

• New design for easier assembly.

• Secure rope attachment with clamp lock.

• Produced of high quality EPDM rubber.

Resistant to weather, ozone and salt water.

Wind the cord 2-3 times round the snubber.

Finish by threading the cord through the other end of the snubber.

175

225

120

180

140

160

Load (Kg)

Elongation (mm)

100

Download PDF