2 person required
Take the two bench ends
and slide a slat into the
chanels and fix in the middle
position using bolt flat
washer , spring washer
and nut .
(See fig .1)
Then slide in the rest of the
slats working outwards using
bolts flat washers , spring
washers and nut .
(See
fig.1)
Then use nut covers to
cover the nuts on the bench
,
s
back.
Take the centre support bar
and line up the holes with each
slat. Make a pilot hole and fix
with woodscrews .(See fig.3)
Using bolts ,washers ,
spring washer and nuts ,
fix the side support bar to the
bench end and .
Then screw the other end of the
support bar to the slat using a
bradawl to make a pilot hole for
woodscrew .(See fig.3)
It will take effort to
complete this step.
3
fig.1
fig.3
4
5
4