3
Plug the other end of this cable into the Ethernet
port of the
INTELLINET NETWORK SOLUTIONS
HomePlug Turbo Ethernet Bridge
.
Plug the AC power cord into the electrical port of the
bridge. Plug the other end of the power cord into an electrical outlet.
NOTE: Because the HomePlug Turbo Ethernet Bridge
sends data over the power lines of your house, plug
the bridge directly into an electrical outlet. It’s
recommended that you not plug the device into a
power strip with surge protection. Also, do not
plug the device into a UPS (uninterruptible
power system). The bridge has its own power
filter for protection against surges.
The installation of the
HomePlug Turbo Ethernet
Bridge
is complete! If you want to configure the bridge, proceed to Software Installation.