GWMS2 Wall Mounted Switch Kit
For Use With FMI PRODUCTS, LLC Manufactured Remote
Remote-Ready Log Sets, Cast Iron Stoves or Fireplace
Systems
Installation Instructions
104919-01
Rev. C
07/09
Manufactured By:
FMI PRODUCTS, LLC
2701 S. Harbor Blvd.
Santa Ana, CA 92704
www.fmiproducts.com
Contents Of Kit
• Switch
• Switch Cover
• 25 ft. Wire
• Mounting Screws (2)
Installation and connection:
1. Connect one terminal of 25 ft. wire to bottom con-
tact of switch located on heater front control panel
(see Figure 1).
WARNING: Do not connect this thermostat or log
set to an electrical source! Electrical shock and/or
re hazard will occur.
2. Connect remaining wire terminal to the “TH” termi-
nal on the control valve (see Figure 1).
3. Route the 25 ft. wire to a convenient location.
IMPORTANT: The wire may be shortened but must
not be lengthened.
4. Connect one bare wire end to each of the terminals
of the provided wall switch.
5. Install the wall switch and cover in the wall.
AUTO
OFF
ON
Figure 1 - Connecting Wire Terminals
To Wall
Thermostat
-
1
