Astria Fireplaces DRT2000 Instruction Sheet

Brand: Astria Fireplaces

Model: DRT2000

Type: Instruction Sheet

THROUGH-WALL

SHIELD KIT

HEARTH PRODUCTS

KITS AND ACCESSORIES

INSTALLATION INSTRUCTIONS FOR THE THROUGH-WALL SHIELD KIT

(MODEL NUMBER: SV4.5-TWSK) (CATALOG NUMBER: H5816)

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

P/N 750247M

REV. A 05/2014

GENERAL INFORMATION

The Through-Wall Shield may be used to shield the Direct Vent Pipe from

blown insulation where required. It is critical to maintain the airspace

clearance free from any material between the shield and the pipe.

If you encounter any problems, need clariﬁcation of these instructions

or are not qualiﬁed to properly install this kit, contact you local distribu-

tor or dealer.

Read this instruction sheet in its entirety before beginning the installation.

ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND

OPERATION MANUALS PROVIDED WITH THE APPLIANCE APPLY TO

THESE INSTRUCTIONS.

INSTALLATION INSTRUCTIONS

Step 1. Cut the Through-Wall Shield to the desired length.

Step 2. Bring both ends of the Through-Wall Shield together to form a

cylinder (see Figure 1).

Step 3. Insert all the remaining locking tabs into the corresponding slots

and bend the tabs inwards to prevent the Through-Wall Shield

from disengaging. Refer to Section “A”-“A” of Figure 1.

Step 4. Bend the mounting tabs (with holes) outwards on the Through-

Wall Shield (see Figure 2).

Step 5. Bend the locating tabs inward on the Through-Wall Shield (see

Figure 3).

Step 6. Position the Through-Wall Shield on the ﬁrestop spacer and

center it by placing the locating tabs to the edge of the circular

opening on the ﬁrestop spacer (see Figure 3).

Step 7. While keeping the Through-Wall Shield centered on the ﬁrestop

spacer opening, drive a screw on each of the four (4) mounting

tabs of the Through-Wall Shield into the ﬁrestop spacer (refer

to Figure 3).

NOTE: To ensure that the screws will not interfere with the termination

assembly, place the Through-Wall Shield so the seam is located at 12 or

6 o’clock (see Figure 4).

Figure 1

Figure 2

Through-Wall Shield

"A" "A"

SECTION "A" - "A"

Firestop

Securing Screws - Four (4)

Through-Wall Shield

Mounting Tabs

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

P/N 750247M REV. A 05/2014

Figure 3 Figure 4

Mounting Tabs

Four (4) Places

Locating Tabs

Four (4) Places

Through-Wall Shield Seam

Located At 12 Or 6 O’Clock

1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210

IHP reserves the right to make changes at any time, without notice, in design, materials,

speciﬁcations, prices and also to discontinue colors, styles and products. Consult your local

distributor for ﬁreplace code information.

Astria Fireplaces DRT2000 Instruction Sheet

Astria Fireplaces DRT2000 Instruction Sheet

Astria Fireplaces DRT2000 Instruction Sheet

Related papers

Other documents