www.IHP.US.com 127166-01A1
750037M Rev. A 10/2014
1508 Elm Hill Pike, Suite 108
Nashville, TN 37210
www.IHP.US.com
P750037M
GENERAL INFORMATION
ROCKER SWITCH KIT
This rocker switch kit may be used with Firecraft Technologies gas
fireplaces. It may be used to turn the main burner on and off. This kit
contains one rocker switch assembly (see figure 1) and these instruc-
tions.
INSTALLATION INSTRUCTIONS FOR ROCKER SWITCH KIT (CATALOG NO. 80L41)
USED WITH FIRECRAFT TECHNOLOGIES GAS FIREPLACES
Printed in U.S.A. © 2000 by FireCraft
P/N 750,037M REV. N/C 4/2000
Step 1. Turn off the fireplace and allow it to cool before proceeding.
Step 2. If the appliance is connected to 120 volt power,
disconnect the power.
Step 3. Open the lower panel/louver assembly by pushing in
simultaneously the left and right side of the panel/louver as-
sembly.
Step 4.
Snap the rocker switch into the rectangular opening of the
bracket attached to the gas valve.
Step 5. On millivolt models, connect the wires to the gas valve
terminals as shown in figure 2. Do not connect this millivolt
gas valve to 120 volt electrical power.
Figure 1
INSTALLATION INSTRUCTIONS
ROCKER SWITCH (ON/OFF) ASSEMBLY
THERMOPILE
ROCKER SWITCH
GAS VALVE
TP-TH
TP
TH
MILLIVOLT GAS VALVE (SIT) CONTROL
CIRCUIT WIRING
DO NOT CONNECT THE MILLIVOLT
CONTROL CIRCUIT TO 120 VOLTS
If any of the original wire as supplied must be replaced, it must be
replaced with type AWM 105 degree C - 18 gauge wire.
Figure 2
DECORATIVE GAS APPLIANCE
KITS AND ACCESSORIES
This rocker switch kit may be used with Innovative Hearth Products gas
replaces. It may be used to turn the main burner on and off. This kit con-
tains one rocker switch assembly (see gure 1) and these instructions.
/