Astria Fireplaces MHD35/MHD40 Instruction Sheet

Brand: Astria Fireplaces

Model: MHD35/MHD40

Type: Instruction Sheet

www.IHP.US.com 127166-01A1

750037M Rev. A 10/2014

1508 Elm Hill Pike, Suite 108

Nashville, TN 37210

www.IHP.US.com

P750037M

GENERAL INFORMATION

ROCKER SWITCH KIT

This rocker switch kit may be used with Firecraft Technologies gas

fireplaces. It may be used to turn the main burner on and off. This kit

contains one rocker switch assembly (see figure 1) and these instruc-

tions.

INSTALLATION INSTRUCTIONS FOR ROCKER SWITCH KIT (CATALOG NO. 80L41)

USED WITH FIRECRAFT TECHNOLOGIES GAS FIREPLACES

P/N 750,037M REV. N/C 4/2000

Step 1. Turn off the fireplace and allow it to cool before proceeding.

Step 2. If the appliance is connected to 120 volt power,

disconnect the power.

Step 3. Open the lower panel/louver assembly by pushing in

simultaneously the left and right side of the panel/louver as-

sembly.

Step 4.

Snap the rocker switch into the rectangular opening of the

bracket attached to the gas valve.

Step 5. On millivolt models, connect the wires to the gas valve

terminals as shown in figure 2. Do not connect this millivolt

gas valve to 120 volt electrical power.

Figure 1

INSTALLATION INSTRUCTIONS

ROCKER SWITCH (ON/OFF) ASSEMBLY

THERMOPILE

ROCKER SWITCH

GAS VALVE

TP-TH

MILLIVOLT GAS VALVE (SIT) CONTROL

CIRCUIT WIRING

DO NOT CONNECT THE MILLIVOLT

CONTROL CIRCUIT TO 120 VOLTS

If any of the original wire as supplied must be replaced, it must be

replaced with type AWM 105 degree C - 18 gauge wire.

Figure 2

DECORATIVE GAS APPLIANCE

KITS AND ACCESSORIES

This rocker switch kit may be used with Innovative Hearth Products gas

replaces. It may be used to turn the main burner on and off. This kit con-

tains one rocker switch assembly (see gure 1) and these instructions.

Astria Fireplaces MHD35/MHD40 Instruction Sheet

Astria Fireplaces MHD35/MHD40 Instruction Sheet

Astria Fireplaces MHD35/MHD40 Instruction Sheet

Related papers

Other documents