NOTE: This guide is designed to be used as a tool to assist the user when building their Timberline and Timberline XL into an outdoor kitchen space, and to ensure
a safe and eective experience.
DISCLAIMER: The built-in grill is mounted on casters. For a flush surface between grill and counter, refer to the Timberline Outdoor Kitchen Trim Kit.
T12133
TIMBERLINE
&
TIMBERLINE XL
BUILD-IN
INSTRUCTIONS
2
A MAJOR CAUSE OF FIRES IS FAILURE TO MAINTAIN REQUIRED CLEARANCES (AIR SPACES) BETWEEN COMBUSTIBLE
MATERIALS AND YOUR GRILL. IT IS OF UTMOST IMPORTANCE THAT THIS PRODUCT BE INSTALLED ONLY IN
ACCORDANCE WITH THESE INSTRUCTIONS AND YOUR TRAEGER® GRILL OWNER’S MANUAL.
Please read all instructions and warnings in this Installation Guide and your Traeger
®
Grill Owner’s Manual before installing.
Scan the QR Code below to take you to the Timberline Owner’s Manual. Failure to follow these instructions could result in
property damage, bodily injury, or even death. We highly recommend you use a licensed contractor to build your
Traeger
®
Grill into an outdoor kitchen. Provide these instructions and your Traeger
®
Grill Owner’s Manual to your contractor
prior to installation. Observe all building codes and re ordinances when installing your Traeger
®
Grill. Contact your local building
inspector or re ofcial for information about inspection requirements in your area. SAVE THESE INSTRUCTIONS.
w WARNING Fire Hazard
• When operating your Traeger
®
Grill, observe all MINIMUM
clearances provided in these instructions and recommended
by your contractor or local authorities.
• Do not install your Traeger® Grill on or near any combustibles,
including combustible oors, countertops, cabinets, railing,
home siding, window frames, furniture, trees, and trash
receptacles, etc. If you have questions on which materials are
considered combustible, contact your local building materials
supplier or re department.
• Only use your Traeger® Grill outside in a well-ventilated area.
This grill is intended for OUTDOOR USE ONLY.
• Never install your Traeger® Grill in a garage, breezeway, shed,
or any other enclosed space. Ensure your Traeger® Grill is
installed in a location where there is enough room to safely
evacuate the area in case of a re.
• Never modify your Traeger® Grill or install any parts or
components not authorized by Traeger. Any modication
of your Traeger® Grill or installation of unauthorized parts or
components will void the warranty and may create a safety
hazard including, without limitation, a re.
w WARNING Electrical Shock Hazard
• Ground Fault Circuit Interrupter (GFCI) protection must
be provided on the circuit(s) or outlet(s) to be used for
the operation of your Traeger® Grill.
• If using an extension cord, only use an extension cord suitable
for outdoor use, to prevent electric shock in accordance with
the instructions and warnings accompanying that product.
This type of cord is designated with “W-A” or “W” on the
cord’s jacket, such as an extension cord of cord type: SW-A,
SOW-A, STW-A, STOW-A, SJW-A, SJOW-A, SJTW-A, or
SJTOW-A.
• Do not modify the plug on your Traeger® Grill, the extension
cord receptacle, or the extension cord plug in any way,
including by removing the ground (earth) prong.
• Keep all electrical plugs, outlets, and cords clear of snow and
standing water and away from hot surfaces.
IMPORTANT SAFETY PRECAUTIONS
READ ALL INSTRUCTIONS BEFORE INSTALLING AND USING
YOUR TRAEGER® GRILL
3
A
FRONT VIEW OF GRILL
B
C
TOP VIEW OF GRILL
CLEARANCE TO COMBUSTIBLE MATERIALS
w WARNING Grill (free-standing or built-in) must
maintain a minimum distance of 18" (45.7 cm) from any
nearby combustibles, including wooden railing, home siding,
window frames, furniture, trees, and trash receptacles, etc.
NOTE: For clearance distance to combustible materials above the grill, refer
to your local codes requirements for outdoor kitchens.
DIMENSIONS (IMPERIAL) REQUIRED CLEARANCES (AIR SPACES)
TO COMBUSTIBLE MATERIALS
A *DEFER TO LOCAL CODES AND REGULATIONS
B 18" 18"
C 18" 18"
DIMENSIONS (METRIC) REQUIRED CLEARANCES (AIR SPACES)
TO COMBUSTIBLE MATERIALS
A *DEFER TO LOCAL CODES AND REGULATIONS
B 45.7 cm 45.7 cm
C 45.7 cm 45.7 cm
4
25 3/4"
MINIMUM
25 3/4"
MINIMUM
1"
1"
3"
4"
24 1/4" 24 1/4"
50 13/16"
36"
STANDARD
COUNTER
HEIGHT
39 27/32"
MAXIMUM
BACKSPLASH
HEIGHT
30"
RCMD
COUNTER
DEPTH
(24" MIN)
CABINET DESIGN AND MEASUREMENTS (MINIMUMS)
A Minimum counter depth is 24" (61 cm).
B See page 11 for receptacle location information.
1 Countertop must be wide enough for Induction Cooktop to be 3"
(7.6 cm) from any edge (see page 7).
2 Recommended cabinet width for installing a Timberline XL is 50 13/16"
(129.5 cm). If installing a Timberline, minimum cabinet width is
39 3/10" (99.8 cm).
A
B
1
2
5
GRILL CLEARANCES
w WARNING A minimum distance of 2" (5.1 cm) from
backsplash or another surface is required for the exhaust.
C Recommended for ease of installation.
D Required minimum distance for exhaust performance. Minimum
distance is 2" (5.1 cm).
8 7/16"
GRILL TO
BACKSPLASH
DISTANCE
1/4"
RCMD
GRILL TO
CABINET
DISTANCE
1/4"
8 7/16"
50 9/32"
21 9/16"
25 1/16"
3 7/32"
3 27/32"
51 3/4" 51 3/4"
D
C
6
LID CLEARANCE REQUIREMENTS
E Maximum backsplash height is 39 27/32" (101.2 cm).
F From rear face of grill barrel, lid overhang is approximately 12" (30.5 cm)
when lid is open.
39 27/32"
MAXIMUM
BACKSPLASH
HEIGHT
1/8"
OPEN LID
CLEARANCE
1 5/8"
LID
OVERHANG
F
E
7
INDUCTION COOKTOP LOCATION OPTIONS
Timberline and Timberline XL Induction Cooktops are located on the lef side
of the grill, but can be built into either side of the cabinets in your outdoor
kitchen. The Induction Cooktop must be a minimum of 3" (7.6 cm) from any
edge. The Timberline Outdoor Kitchen Trim Kit includes a 6 f. extension cord
for the Induction Cooktop.
INDUCTION COOKTOP – RIGHT SIDE
INDUCTION COOKTOP – LEFT SIDE
8
G Cooktop must be 3" (7.6 cm) from any edge.
Dimensions provided are for the proper fit of the Induction Cooktop into the
outdoor kitchen counter.
Dimensions in in Detail A must reference the red and blue lines on either side.
Tolerance of measurements is + 1/32" (unless otherwise specified).
INDUCTION COOKTOP CUTOUT DIMENSIONS
A
LEFT CABINET
RIGHT CABINET
3"
3"
13 15/32"
19 3/8"
17/32"
6 23/32"
45°
45°
R3/8"
R3/8"
R5/32"
R1 13/32"
6 23/32"
45°
15/32"
4 1/32"
1 25/32"
1 25/32"
4 1/32"
DETAIL A
SCALE 1 : 5
G
-
9
IMPORTANT:
• Ventilation is required for performance of the Induction Cooktop.
• Exhaust and intake airflows must be separated for proper operation.
• Keep the cabinet space below the Induction Cooktop empty for proper
airflow and eciency.
H 18" (45.7 cm) is the minimum vent width for proper performance.
I A minimum of 4.5" (11.45 cm) of empty space is required from the
bottom of the Induction Cooktop.
INDUCTION COOKTOP VENTILATION
AA
18"
MINIMUM
VENT
WIDTH
2 11/16"
1"
4"
22 1/4"
4 1/2"
MINIMUM
EMPTY SPACE
BELOW COOKTOP
6"
MINIMUM
EMPTY CABINET
SPACE
SECTION A-A
I
H
10
IMPORTANT:
• The exhaust and intake airflow must be separated for proper operation of
the Induction Cooktop.
• The Induction Cooktop partition material must be NON-COMBUSTIBLE.
J The closed cell foam rubber will need to be cut for the Induction
Cooktop to sit properly in the countertop (see detail D).
K Ensure the closed cell foam rubber is flush with the bottom surface of
the Induction Cooktop.
L The minimum distance from the front wall of the cabinet to the front of
the partition is 7 1/8" (18 cm). The partition separates the intake from
the exhaust on the Induction Cooktop.
ITEM NO. DESCRIPTION QTY.
1 INDUCTION COOKTOP PARTITION 1
2 3/8"-THICK CLOSED CELL FOAM RUBBER 1
INDUCTION COOKTOP PARTITION
1
2
CC
DETAIL D
SCALE 1 : 3
22 1/4"
4 7/16"
4 13/16"
2"
3/8"
B
B
7 1/8"
MINIMUM
PARTITION
DISTANCE
28"
SECTION B-B
22 1/4"
D
SECTION C-C
J
K
L
11
OUTLET/POWER CORDS
Review Electrical Shock Hazard in Important Safety Precautions.
Defer to local ordinances for installation of electrical outlets.
M Acceptable wall outlet locations
N For Induction Cooktop power cord, a cutout will be needed on the
inside wall of the cabinet (side of cooktop) to pass cord through.
NOTES:
• Induction Cooktop power cord length is 60" (152.5 cm).
• Grill power cord length is 40.5" (102.9 cm).
12"
9 1/4"
18"
36"
5 11/16"
21 1/4"
E
E
1 1/2"
MINIMMUM
4"
5"
3 1/2"
SECTION E-E
SCALE 1 : 17
M
N
12
/
