Boss SDE-3000EVH Owner's manual

Type
Owner's manual
*5100084681-02*
Usage of Ground Lift Cable
You may hear a humming noise when more than one amp is connected to this unit.
To disconnect the ground from the OUTPUT jacks, use the ground lift cable included with this unit.
For details on hum noise, see “Dealing with hum noise” in the Reference Manual.
EFX R
(DRY+WET)
EFX L
(DRY+WET)
Preamp
INPUT
To preamp input jack
To amp return jack To amp return jack
From preamp
send jack
Speaker
DIRECT
(DRY)
To preamp
return jack
Use the ground lift cable to reduce noise.
Using the Included Ground Lift Cable
The ground wire is disconnected from the female jack of the cable
that’s included.
Connect this cable to the cable that’s connected to the OUTPUT jacks.
GND is disconnected.
Included cable
NOTE
You can use it only when the power supply is 3P (3 poles). When this is set
to 2P, the ground is cut o, so no sound is produced.
Do not connect the ground lift cable to any other jack besides OUTPUT.
Doing so may cause a malfunction.
SDE-3000EVH
© 2023 Roland Corporation
  • Page 1 1

Boss SDE-3000EVH Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI