D) Input your home SSID & password:
Note: that eWeLink only supports 2.4GHz Wi-Fi communication
protocol, 5G-WiFi networks are not supported.
E) Name your Device to complete setup.
If the Device status is “Offline” on eWeLink, the device may
require up to 1 minute to connect to your router and server. If the
green LED on, the device is “Online”, but eWeLink still shows
“Offline”, please close the eWeLink and re-open.
1. WiFi Remote Control and Device State
Turn your Device on off by tapping on device icon. Device State
will always Display on the APP.
3. Scheduling your Device
eWelink Supports a maximum of 8 enabled
single /repeat/countdown timing schedules for each device.
Click the Share icon, input the eWeLink account (phone number
or email address) with whom you want to share. Toggle the
account holders’ permissions (edit/delete/change/enable) you
would like to give, then click Next. The account holder will receive
an invitation message. They must Click Accept; the device has
shared successfully. The other user will now have access to control
your device.
2. Share Control of your Device with others
1. Download and install the eWelink APP
Open the Transmitter lid to gain access to the
terminal connectors and dip switches.
You may Scan the QR Code below to download eWeLink.
Or Search “eWeLink” in APP Store for iOS versionor
Google play for Android version.
FOLLOW THE STEPS BELOW TO
CONNECT TO YOUR
MIGRO WI-FI SMART CONTROLLER
4. Set Default Power Status
In Device Settings, you can set default device status: ON or OFF
when the device is power on.
Don’t Forget to Connect your eWeLink Account to:
Scene allows triggering on/off your devices automatically. Scene
Settings is in the upper right corner of Device List. You can set up
scenes or smart scenes to trigger on/off the device.
Users should select “Click to execute” in the condition, add
different existing devices, name the scene and save it.
The APP will notify you of any new firmware or APP versions.
Please update as soon as you possible
A) Power up Your MIGRO Smart Wi-Fi Controller after you
complete the APP installation.
B) On the white Sonoff Smart Switch, Press the black button for 7
seconds until the green LED blinks rapidly.
Open eWeLink app, click”+”, you’ll see the pairing icons. Please
select the pairing mode according to below instructions:
Once the Green LED is Blinking:
1. Selectthe Quick Pairing Mode (TOUCH). Otherwise, it will fail
to add the device. ClickNext.
C) It will auto-search and connect smart home
device around you.
2 .If required, register a new account.
You`ll need to enter your phone number/email
address and a password (at least 8 characters).Enter
the SMS verification code to register.
3. Login to your account.
