EchoMaster PMM-7333-PL is a 7.3-inch factory mount mirror monitor that enhances your vehicle's safety and awareness. With three video inputs, you can connect multiple cameras, including a rearview camera for easy parking assistance. It features adjustable parking lines for precise alignment and three triggers to activate cameras when needed. The auto-dimming display ensures clear visuals even in bright conditions, and the remote control provides convenient operation.
EchoMaster PMM-7333-PL is a 7.3-inch factory mount mirror monitor that enhances your vehicle's safety and awareness. With three video inputs, you can connect multiple cameras, including a rearview camera for easy parking assistance. It features adjustable parking lines for precise alignment and three triggers to activate cameras when needed. The auto-dimming display ensures clear visuals even in bright conditions, and the remote control provides convenient operation.
User Manual
7.3” Factory Mount Mirror Monitor with 3 Video
Inputs, 3 Triggers and Adjustable Parking Lines
PMM-7333-PL
3
email - [email protected] (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (Europe)
Installation Guide
2
Installation Guide
email - [email protected] (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (Europe)
Fitting Instructions
PMM-7333-PL
7.3” Factory Mount Mirror Monitor
with 3 Video Inputs, 3 Triggers and
Adjustable Parking Lines
Introduction
Box Contents Key Features
u User Guide
u Mirror Monitor
u Main Harness
u Remote Control
Thank you for purchasing your EchoMaster Pro automotive monitor.
Your monitor displays a clear, high resolution image of the area
surrounding your vehicle, meaning your maneuvering and vehicle
awareness will be greatly improved.
Please ensure you read and understand all aspects of this manual before
tting or using your EchoMaster monitor.
Operating Instructions
u 3 video inputs
u 3 triggers
u Remote control included
u Adjustable parking lines
u Auto-dimming display
PMM-7333-PL
7.3” Factory Mount Mirror Monitor
with 3 Video Inputs, 3 Triggers and
Adjustable Parking Lines
The PMM-7333-COM-PL will replace your factory tted rearview mirror.
Remove the original mirror from the vehicle and replace with the
PMM-7333-COM-PL.
Once the unit is in place, run the connections cable across the headliner of
the vehicle and down the A pillar.
Please ensure that you do not impede the operation of any airbags that may
be located in the A pillar of the vehicle. Any cable passing these airbags
should be run behind the airbag and not in front of it.
Once the cable has been routed down to the dashboard, connect the
camera inputs and power connections as shown in the wiring diagram
section of this manual.
The vehicle ignition is required to be on for the unit to operate.
To turn it on press the POWER button.
To switch between video display modes touch the black area to the left side
of the screen and you will see 3 touch buttons appear. The center of these
will switch the video input.
The bottom symbol will adjust the image setting to one of 4 preset settings.
The top ‘R’ button will instantly switch to the reverse input.
5
email - [email protected] (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (Europe)
Installation Guide
4
Installation Guide
email - [email protected] (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (Europe)
Operating Instructions (continued)
Wiring Diagram
PMM-7333-PL
7.3” Factory Mount Mirror Monitor
with 3 Video Inputs, 3 Triggers and
Adjustable Parking Lines
PMM-7333-PL
7.3” Factory Mount Mirror Monitor
with 3 Video Inputs, 3 Triggers and
Adjustable Parking Lines
All other functions are controlled by the supplied remote.
You can access all adjustable parameter by pressing the MENU button on
the remote.
Adjustable parameters are as follows.
Brightness: Adjust the brightness of the screen.
Color: Adjust the color of the screen.
Contrast: Adjust the contrast of the screen.
Scale: This turns the parking guide line for the reverse input on or off.
Start Logo: This enables or disables the boot-up logo when the screen is
powered up.
Preset: This resets all values to default.
You are also able to adjust the on-screen position of the parking lines to
ensure accurate positioning for your particular vehicle. To enter this setting
press the center button on the remote D pad (this menu is only accessible
when the reverse image is being displayed).
Pressing the center button will toggle between the left (XL) guideline and
right (XR).
Use the 4way D-pad to adjust the physical position of the guidelines
independently.
The buttons to the left and right of the MODE button will adjust the angle
of the guidelines.
To set the lines accurately place some 2” wide tape at the rear of the
vehicle parallel to each other. The tape should be about 12ft long and 6”
outside the maximum width of the vehicle (please see image on the next
page). It must be visible on the display when the vehicle is in reverse.
You can then set the guidelines to
match the tape.
Press the center button again to
exit the guideline setup screen.
+12V Ignition
GND
Video 1
Reverse
Video 2
(Black)
(Red)
Trigger 2
Trigger 1 (Purple)
(White)
Reverse Trigger (Green)
FILTER &
FUSE BOX
IN
OUT
2” Wide Tape
12ft
6”
7
email - [email protected] (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (Europe)
Installation Guide
6
Installation Guide
email - [email protected] (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (Europe)
Specications
PMM-7333-PL
Screen Size 7.3”
Aspect Ratio 16:9
Power Supply 9-18V DC
Resolution 480 x 272
Luminance 1000-1400
Contrast 400:1
TV Format AUTO
OSD Languages Multi
Video Inputs 3
Audio Inputs N/A
Triggers 3
Current Draw 75mA
Operating Temperature -20C - +70C
IP Rating N/A
Parking Guidelines Adjustable
Dimensions (mm) 240 x 87 x 50
Connector Type Power & RCA
Dimensions (mm)
PMM-7333-PL
7.3” Factory Mount Mirror Monitor
with 3 Video Inputs, 3 Triggers and
Adjustable Parking Lines
PMM-7333-PL
7.3” Factory Mount Mirror Monitor
with 3 Video Inputs, 3 Triggers and
Adjustable Parking Lines
email - [email protected] (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (Europe)
tel - +44(0)1420 487110 (Sales) - +44(0)1420 470618 (Technical)
15500 Lightwave Drive, Suite 202, Clearwater, Florida 33760
Woolmer Way, Bordon, Hampshire, United Kingdom
EchoMaster is a Power Brand of AAMP Global.
EchoMaster.com
-
1
-
2
-
3
-
4
-
5
EchoMaster PMM-7333-PL User manual
- Type
- User manual
- This manual is also suitable for
EchoMaster PMM-7333-PL is a 7.3-inch factory mount mirror monitor that enhances your vehicle's safety and awareness. With three video inputs, you can connect multiple cameras, including a rearview camera for easy parking assistance. It features adjustable parking lines for precise alignment and three triggers to activate cameras when needed. The auto-dimming display ensures clear visuals even in bright conditions, and the remote control provides convenient operation.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
EchoMaster PMM-43-ADPL User manual
-
-
-
-
EchoMaster 19433433 Installation guide
-
PAC Third Brake Light Camera PCAM-CHMSL2-FD15 Installation guide
-
Other documents
-
Stinger Off-Road MRCHDDVRJW Installation guide
-
Phoenix Gold Z 6.5" Component Speaker User manual
-
Stinger Off-Road EM-BUC-KIT-JW Installation guide
-
Phoenix Gold Z 4 x 6" Coaxial Speaker User manual
-
Stinger MX 6x9" Dual Concentric Coaxial Speakers User manual
-
-
-
Davis Instruments 152 Owner's manual
-
-
