Courtesy of: DiscountCarStereo.com

1989-UP MITSUBISHI /DODGE RADIO/AMP REPLACEMENT KIT

The HRC-MIT and C2A-MIT converts Infinity 6-pin DIN socket on Mitsubishi radio/amplifier into an RCA level (4-channel &

amp trigger). Purchase one of these interfaces to replace the factory OE head unit with an aftermarket OR to replace the

factory OE amplifier and speakers.

Use diagrams below to make the proper connections based on application.

Noteworthy: 1. A Low voltage trigger may be required when replacing the Infinity amplifier.

2. Includes 14-pin power/speaker harness

©1995-March 22 DiscountCarStereo.com. All rights reserved. Information in this document is subject to change without notice. Other products and companies

referred to herein are trademarks or registered trademarks of their respective companies or mark holders.