Minka-Lavery 2382-77 User manual

Brand: Minka-Lavery

Model: 2382-77

Type: User manual

Minka-Lavery 2382-77 is a lighting fixture that can be used to replace old fixtures. It comes with all the necessary parts for installation, including mounting hardware and screws. The fixture is easy to install and can be completed in a few simple steps. It is important to turn off the power at the circuit breaker before starting the installation. The fixture can be used with a variety of light bulbs, but it is important not to exceed the maximum wattage rating. Once the fixture is installed, it will provide light for your home or office.

Fig.1

INSTALLATION INSTRUCTIONS

Item#2382-77(New.2018/1/10)

READ AND SAVE THESE INSTRUCTIONS

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Fig. 2

HANGING THE FIXTURE (Fig. 1)

1. Carefully remove the fixture from the carton and

check that all parts are included as shown in the

illustration.

2. Shut off power at the circuit breaker and remove old

fixture including the mounting hardware.

3. Removed the mounting bracket (C) from the fixture

body (B) by unscrewing the mounting screw (A)

CONNECTING THE WIRES (Fig. 2)

4. At this point, connect the electrical wires as shown in

(Fig.2), Make sure that

all wire connections are

secured. If your outlet has a ground wire (green or

bare copper), connect the fixtures Ground Wire to it.

Otherwise, connect the fixture Ground Wire directly

to the circular strap using the Green Screw provided.

Secure the mounting plate (C) by inserting the wood

screws (H) through the holes on the mounting plate

into the plastic anchors.

6. The mounting bracket (C) contains several pairs of

threaded holes, find the pair of holes that match the

holes spacing in your Junction box(E). Attach the

mounting bracket (C) to the Junction Box(E) using

the two mounting screws (G)( size: 8/32*25mm).

Tighten the screws (G) securely with screwdriver.

The side of the mounting plate marked “GND” must

face out.

7. Secure the fixture body (B) to mounting bracket (C)

with the mounting screw(A).

INSTALL LIGHT BULB (Fig. 1)

8. Install light bulb (F) (not included) in accordance with

the fixture’s specifications.

(DO NOT EXCEED THE

MAXIMUM WATTAGE RATING!!) (NE PAS DEPASSER LA

PUISSANCE NOMINALE MAXIMALE!)

FINISH THE INSTALLATION (Fig. 1)

9. Your installation is complete now. Return power to

the junction box and test the fixture. Note:

Illustration (Fig.1

) on this manual is for

installation purposes only. It may or may not be

identical to the fixture purchased

2382-77

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black

(Hot)

FIXTURE

WIRES

White or

Ribbed

HOUSE

WIRES

White

(Neutral)

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

Green

(Ground)

- Set #A-022-147300

- Mounting bracket

-Ground Screw

-Mounting Screw*2

MIN 75

℃

SUPPLY CONDUCTORS

Minka-Lavery 2382-77 User manual

Minka-Lavery 2382-77 User manual

Minka-Lavery 2382-77 User manual

Related papers

Other documents