Kenwood AT-180 Operating instructions

Type
Operating instructions

Kenwood AT-180 is an antenna tuner for use with the Kenwood TS-180S transceiver. It consists of an antenna coupler, through-line RF wattmeter, SWR meter, and antenna switch. The AT-180 can be used on the amateur bands between 1.8MHz and 30MHz. The RF wattmeter has two ranges, 20W and 200W, and the antenna switch has four outputs for coaxial fed antennas, wire antennas, and a dummy load. The antenna matching circuit acts as a band-pass filter, reducing TVI.

Kenwood AT-180 is an antenna tuner for use with the Kenwood TS-180S transceiver. It consists of an antenna coupler, through-line RF wattmeter, SWR meter, and antenna switch. The AT-180 can be used on the amateur bands between 1.8MHz and 30MHz. The RF wattmeter has two ranges, 20W and 200W, and the antenna switch has four outputs for coaxial fed antennas, wire antennas, and a dummy load. The antenna matching circuit acts as a band-pass filter, reducing TVI.

  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

Kenwood AT-180 Operating instructions

Type
Operating instructions

Kenwood AT-180 is an antenna tuner for use with the Kenwood TS-180S transceiver. It consists of an antenna coupler, through-line RF wattmeter, SWR meter, and antenna switch. The AT-180 can be used on the amateur bands between 1.8MHz and 30MHz. The RF wattmeter has two ranges, 20W and 200W, and the antenna switch has four outputs for coaxial fed antennas, wire antennas, and a dummy load. The antenna matching circuit acts as a band-pass filter, reducing TVI.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI