This kit should only be installed by an
authorized Öhlins Service Centre!
Öhlins Racing AB cannot be held responsible
for any personal injury or damage that may
occur after installing the Öhlins spring kit.
Contact an Öhlins Service Centre for advice
about how to install and maintain this
product properly.
Öhlins Racing AB, Box 722,
S-194 27 Upplands Väsby, Sweden
Phone +46 8 590 025 00, Fax +46 8 590 025 80,
E-mail: info@ohlins.se, www.ohlins.com
Read more at www.ohlins.com
Replace the standard spring with the Öhlins
spring. Install in the same way as the original
unit.
HOW TO INSTALL
Congratulations!
With this purchase you have made a clear
statement...the high performance Front fork
Spring Kit from Öhlins Racing is nothing but
pure racing breed which means that you have
taken one more step to eliminate luck on your
motorcycle.
The balance between your front fork and
rear suspension will sharpen up and the perfor-
mance of your front fork will improve...30 years
of racing experience is now a crucial part of
your riding experience.
SPRING KIT
FRONT FORK
Part no. 01200-04
Part no. 08809-01
KAWASAKI ZX-9R
NOTE!
The spacer included in this kit
should be installed together
with the spring. The spacers
shall be mounted at the top of
the spring - see sketch here
beside.
Notice that for this bike the
Öhlins springs are softer
(1.0 kgf/mm) than the standard
springs (1.1 kgf/mm).
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Ohlins 08807-01 Mounting Instruction
-
-
-
-
-
-
-
-
-