4” WALL MOUNT
INSTALLATION
30 Samuel Barnet Blvd.
New Bedford, MA 02745
(508) 995-2200
Page 1
PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR,
ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY,
OR HARDWARE STORE FOR REFERRALS).
Slip the swaged end of mast A into the
round end of mast B.
1
2
WOOD BLOCK
SWAGED END
Tap the two sections together with a hammer.
A piece of wood will protect the end from
damage.
MAST B
SWAGED
END
MAST A
MAST B
MAST A
CLAMPING
SCREWS
Select a location that will provide the highest,
unobstructed position for the wind sensors.
3
MAST
HAMMER
TAPE MEASURE
3/8”
3/8” WRENCH
TOOLS
REQUIRED
DRILL WITH
1/8” DRILL BIT
LEVEL
BRACKET WILL
ACCOMMODATE
UP TO 4 INCH
OVERHANG OF EAVE
4 INCH WALL
BRACKET
ROOF
PEAK
PHILLIPS SCREW
DRIVER
SLOTTED SCREW
DRIVER
4” WALL MOUNT
INSTALLATION
30 Samuel Barnet Blvd.
New Bedford, MA 02745
(508) 995-2200
Page 2
1/8” PILOT
HOLES
4
Drill two 1/8” level pilot holes 8 1/4” apart for each
bracket. Brackets must be separated from each
other by at least 18” for mast stability. Both
brackets must be aligned vertically for the mast
to be straight when installed.
5
6
Slip mast into brackets and tighten
with the carriage bolts.
4 INCH
BRACKET
MAST
ROOF
PEAK
8 1/4”
18”
MINIMUM
LEVEL
ROOF
PEAK
4 INCH
BRACKET
CLAMPING
SCREWS
LAG SCREWS
Secure the brackets
with the lag screws
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Maximum Wall Mount Owner's manual
-
-
-
-
-
-
-
-
-
Other documents
-
CUSHCRAFT MA-6B User manual
-
Hygain TH-2MK3 Owner's manual
-
Ambient Weather EZ-30-12 Owner's manual
-
RCA ANT2020X User manual
-
Ambient Weather EZ-48-3AB-125-35 Owner's manual
-
-
-
Ambient Weather WEATHERMOUNT Owner's manual
-
-
Ambient Weather EZ-NPP User manual
