Kmart 42848127 User manual

1.ENSURE YOU HAVE ALL PARTS BEFORE YOU START ASSEMBLING.

2.DO NOT OVERTIGHTEN THE BOLT.

3.ASSEMBLE ON A CLEAN SOFT CARPETED SURFACE TO AVOID SCRATCHING THE SURFACE OF

THE CHAIR.

4.WHEN CLEANING THE SURFACE, USE A DAMP CLOTH OR DRY CLEAN CLOTH. DO NOT USE

ABRASIVE MATERIALS AND SOLVENTS. KEEP AWAY FROM DIRECT SUNLIGHT.

5.CHECK TIGHTNESS OF BOLTS EVERY 4-6 WEEKS.

WARNING:

• DO NOT STAND ON THE CHAIR.

• DO NOT USE THE CHAIR AS A STEP LADDER.

• USE FOR ONE PERSON ONLY.

• DO NOT USE THE CHAIR UNLESS ALL BOLTS, SCREWS AND KNOBS ARE FIRMLY SECURED.

• DO NOT DRAG THE CHAIR ON THE WOODEN FLOOR.

FAILURE TO FOLLOW THESE WARNINGS COULD RESULT IN SERIOUS INJURY.

THIS PACKAGE CONTAINS SMALL PARTS AND SHARP POINTS.

KEEP AWAY FROM CHILDREN AND BABIES UNTIL ASSEMBLY IS COMPLETE. ADULT ASSEMBLY REQUIRED.

MAXIMUM SAFE LOAD: 100KGS.

M6x13mm M6x70mm M6x45mm

ASSEMBLY INSTRUCTIONS - TIMBER OCCASIONAL CHAIR

CAUTION:

PLEASE READ THESE INSTRUCTIONS CAREFULLY.

F x2 G x4 H x2 I x5 J x1

•TAKE CARE IF USING POWER TOOLS TO ASSEMBLE THE PRODUCT.

M6x80mm 80x25mm

K x6

M6(outer dia 16x2mm)

Step 1. Using the hex key (PART J), join the piece (PART C)

into (PART A) and (PART B) with the bolts (PART I)

and washers (PART K).

3Step 1. Using the hex key (PART J), join the piece (PART D)

into (PART A) and (PART B)

At the same time join the piece (PART E) into (PART C) &

(PART D) with the bolts (PART H) and washers (PART K) and

barrel nut (PART G).

Step 2. Tighten the bolts closest before using the chair.

with the bolts (PART I) and washers

(PART K).