Hang-Fast System
Oneida Air Systems, Inc. 1001 W. Fayette St. Syracuse, NY 13204
800.732.4065 315.476.5151 Fax 315.476.5044 www.oneida-air.com
At Oneida Air Systems, Inc. we offer Gripple Hang-Fast Systems as a means
of hanging or securing ductwork. It is a simple and secure system that works.
Each system comes complete and ready to use. Each kit comes with a Gripple Hang-Fast grip,
rope sling with a pre-formed loop at one end, and a setting key.
All wire rope is manufactured to BS 302 and will safely hold up to 175lbs.
Helpful Hint:
Install the duct work low and adjust upwards to desired level.
1
2
3
4
5
Prior to the load being applied, the Hang-Fast Grip can be
disengaged in either direction.
Push the setting key into product and while maintaining
pressure, reposition the grip on the rope and then remove key.
After load has been applied and teeth set into the wire, grip
can only be adjusted by pulling wire through the Gripple and
shortening the wire length.
Then pass the tail through the small loop and
pull tight.
2
Push the tail-end through one channel in the
Grip and pull appropriate length through.
3
Pass tail-end around the ductwork to be
suspended.
4
Return the rope to the Grip and push through
the second channel, then pull rope through to
required length.
5
1Thread tail of wire rope through (or around)
the anchor or eyehook.
Or see other mounting options.
*All eyehooks, etc. are user supplied.
Other Mounting Options
/
