Anvil 805153 Quick start guide

Anvil
Brand
Anvil
Model
805153
Type
Quick start guide
COMPLETE INSTALLATION
SPEED ADJUSTMENT:
TURN VALVE CLOCKWISE TO
DECREASE SPEED, COUNTER-
CLOCKWISE TO INCREASE SPEED.
HINGE
SIDE
DOOR
FRAME
(JAMB)
(4)
LONG
SCREWS
HINGE
SIDE
DOOR
FRAME
(JAMB)
WARNING
BEFORE
locking door bracket,
be sure that lugs on rod are
resting against "Hold-Open
Washer". This will give proper
tension setting for closer.
HOLD
-
OPEN WASHER
AFTER
completed installation,
Move "Hold-Open Washer"
back of lugs on rod.
HOLD-OPEN WASHER
STEP
2
Attach door bracket to closer with long pin as shown. With door tightly
closed and latched, hold
closer
and door bracket
in
level position and mark
Anvil
EvAmark
Mfg# 805153
Pneumatic Door Closer
Cerrador Neumatico Para Puerta
CAUTION: BE SURE TO READ BEFORE DRILLING HOLES
NOTE:
BEFORE INSTALLATION, CHECK DOOR TO SEE THAT
IT CLOSES AND LATCHES FREELY.
Closer may be installed on rail at top of door or on mullion strip near center,
whichever is desired.
STEP
1
At desired height mark hinge side door frame for jamb bracket 1/4" in from
face of storm or screen door and at least 1/2" down from top of frame. Be
sure open side of bracket and arrow faces door. Drill four pilot holes and
fasten bracket with four long screws as shown. Place "Hold-Open Washer"
on rod in front of lugs as shown for correct tension. Use short pin to connect
closer rod to bracket.
LONG
CONNECTING
PIN
REAR HOLE
0
FRONT
HOLE
DOOR
BRACKET
DOOR
CLOSER
(2) SHORT SCREWS
HINGE
SIDE
DOOR
FRAME
(JAMB)
WARNING
BEFORE
locking door bracket,
be sure that lugs on rod are
resting against "Hold-Open •
Washer. This will give proper
tension setting for closer.
AFTER
completed installation,
Move "Hold-Open Washer"
back of lugs on rod.
HOLD-OPEN WASHER
HOLD-OPEN WASHER
STEP
2
Attach door bracket to closer with long pin as shown. With door tightly
closed and latched, hold closer and door bracket in level position and mark
center hole of each slot and drill three pilot holes. Fasten to door with two
short screws as shown. Closer is now ready to operate. Open door and
move "Hold-Open Washer" back of lugs on rod.
Note:
Speed adjustment:
Turn valve clockwise to decrease speed, counter-clockwise to increase speed.
CONTROLLED "EXTRA LATCHING POWER"
Installed as directed above, the closer is in a maximum latching power
position (pin in front hole). If less latching power is required, hold door
open about 8" with "Hold-Open Washer", pull long pin and reconnect in
rear hole.
ANVIL MARKTM
WILMINGTON, DELAWARE
Made In Ta wan
0
  • Page 1 1
  • Page 2 2

Anvil 805153 Quick start guide

Anvil
Brand
Anvil
Model
805153
Type
Quick start guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents