Extension Wand Components
Retention
Strap (2)
Bracket
Important: Before attaching the extension,
ensure the sprayer bottle is empty and the battery
is in o position. When using the extension wand,
the battery or compressor on/o switch should be
used to activate the sprayer.
* Retention
strap will be
damaged
by contact
with oil in
Aprehend
®
Lock Nut (2)
Rubber
Washer (2)
Extension
Wand
Spare parts and replacement
batteries are available from
your supplier or directly from
www.aprehend.com.
Contact ConidioTec
directly if you
experience any
problems with
this equipment.
Extension Wand
Instructions
Wrench
* Spare retention strap, lock nut, and rubber washer are supplied in case of loss.
www.aprehend.com
800.891.8610
Doc.# 40-100-42419
Fill spray gun bottle with
Aprehend
®
and set the spray
gun to the desired angle for
baseboard or ceiling application.
When extension wand is not
needed, the retention strap can
be removed from the trigger and
the spray gun used normally.
Pull the at part of the retention
strap up and over the trigger to
keep the trigger fully depressed.
Angle
Adjustment
Knob
Baseboard Application
Ceiling Application
Insert both
loops of the
retention strap
over the spray
gun handle.
Use the battery or compressor
on/o switch to start and nish
the spray application.
1
Connect the extension wand
to the spray gun as pictured
above by following illustrated
directions to the right.
2
3
Bring the retention strap down
to the air hose nut.
4 5
Extension Wand Assembly and Use
A
B
C
D
A
spray gun
B
insert bracket
C
insert 7/16 ID washer onto
the threaded spray gun air
inlet (1/2 OD)
D
rmly attach the air hose
using the wrench
E
turn on the compressor
and check for auto stop
/
