DVD988
Instruction manual
DVD Home Theater Soundbar System
157g
80g
DVD988
RDS
V1.0
210x145mm
-1-
6 SD/MMC/MS CARD READER
7 VOL+
8 VOL -
9 SOURCE
10 NEXT
11 PREV
-2-
-3-
DVD Home Theater Soundbar System
DVD 988
110V,60Hz
NTSC/PAL
1 (=USA,Canada)
-4-
Peak output power
75W x 2 satellites (4Ω at 1kHz, THD 10%)
150W x 1 subwoofer (8Ω at 100Hz, THD 10%)
4
7
9
11
15
16
20
24
29
31
33
-5-
favor of the COBY DVD Home
Theater Soundbar System DVD 988.
COBY Electronics Corp. - Technical Support
56-65 Rust Street
Maspeth, NY 11378
-6-
FCC Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC rules.
Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such changes or
modifications should be made, you could be required to stop operation of the equipment.
-7-
-8-
-9-
-10-
-11-
deo projector
Vi
Select Video Out from the Video menu. Here you can change the settings
S-Video, Component, RGB, and P-Scan on the playback device that you
have connected. Please see the operating instructions of the connected
device for the correct settings.
-12-
-13-
-14-
-15-
-16-
-17-
-18-
-19-
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/