Tefal BG7030 is a versatile and powerful grill that allows you to enjoy delicious grilled meals indoors or outdoors. It features a large grilling surface, adjustable temperature control, and a water reservoir to prevent flare-ups and ensure even cooking.
Tefal BG7030 is a versatile and powerful grill that allows you to enjoy delicious grilled meals indoors or outdoors. It features a large grilling surface, adjustable temperature control, and a water reservoir to prevent flare-ups and ensure even cooking.
www.tefal.com
Grill'n Pack plaque 05/05 24/5/05 14:31 Page 1
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
17
ENG
Thank you for buying this TEFAL appliance,
which is intended for domestic use only.
Read the instructions in this leaflet
carefully and keep them within reach. They
apply to every version depending on the
accessories that come with your appliance
(NB: the parts with a * in front of their
reference number are only delivered with
certain models).
For your safety, this product conforms to all
applicable standards and regulations (Low
Voltage Directive, Electromagnetic
Compatibility, Food Compliant Materials,
Environment, …).
The appliance is suitable for outdoor use.
TEFAL has an ongoing policy of research and
development and may modify these products without
prior notice.
The drawings shown on page 3 illustrate
the instructions.
Any solid or liquid foodstuff that comes into
contact with the parts marked with
the logo should not be consumed.
Prevention of
accidents in the home
For a child, even a slight burn may
sometimes be serious.
As they grow up, teach your children to be
careful with hot appliances in the kitchen.
If your appliance is used in the company of
children or disabled persons, always use it
under adult supervision.
Do not touch the hot surfaces of the
appliance.
If an accident occurs, rinse the burn
immediately with cold water and call a
doctor if necessary.
Assembly
• Open the appliance by sliding the two
locks (1) towards the outside.
• Open the protection lid (2) until it locks in
the open position.
B
A
If the lid is closed, a device (6a) prevents
the appliance switching on.
• Depending on the model, remove the
storage shelf (*12).
Before first use:
• Remove any packaging, stickers or
accessories inside and outside the
appliance.
• Clean the grill plate (4) : follow the
instructions in the section "After use".
Place the reflector (7) in the base of the
appliance (8): the curved part of the
reflector (7a) must be positioned towards
the front.
Place the heating element (5) on the
reflector (7) then press firmly on the control
panel (6) to position it in the housing
provided for this purpose, so that the safety
system is activated.
If the heating element is incorrectly
positioned, the safety system will
prevent the appliance from working.
Position the grill plate (4) on the appliance
(the pattern 4a must be placed on the back)
and lock it in place using the two
handles (3).
* Depending on model :
• Take out the support legs (*11) stored
underneath the storage shelf (*12).
• Insert the support legs (*11) into the
storage shelf (*12).
• Turn over the storage shelf (*12) and then
open the two supports (*13).
• Place the barbecue on the two
supports (*13).
Make sure that the lugs (*14) are
correctly fitted into the slots (*15)
underneath the appliance.
E/4
E/4
E/3
E/2
E/1
D
D
D
D
C
D
Grill'n Pack plaque 05/05 24/5/05 14:32 Page 17
Connection
and pre-heating
It is essential to pour 4 litres
of water into the base of the
appliance (8) to ensure that
the barbecue works
properly.
Pour the water into the
opening (8a) provided for this
purpose at the rear of the base
of the appliance (8).
If your appliance is not equipped with
support legs ( – *11/*12/*13), place it on
a stable heat resistant surface.
Do not use it on a flexible type of support,
such as a rubberised protective cloth.
Never place the appliance directly onto a
fragile surface (glass table, cloth, varnished
furniture...).
To avoid overheating of the appliance, we
recommend you do not place it in a corner
or against a wall.
Unwind the cord completely.
Check that your electric installation is
compatible with the power and the voltage
indicated under the appliance.
You should regularly examine the power
supply cord so as to detect any signs of
wear. Do not use the appliance if the cord is
damaged.
If the power supply cord is damaged, it
must be replaced by the manufacturer or its
service agent or a similarly qualified
person in order to avoid any danger.
Connect the appliance to a socket with an
earth connection.
Supply the appliance through a residual
current device (RCD) having a tripping
current not exceeding 30 mA.
E
D
D
ENG
18
If an extension cord is used:
- it must be with an incorporated earth
connection;
- take every precaution to ensure that
people cannot become caught up in it.
Plug the cord into the mains.
Never plug the appliance in when not in
use.
Never use the appliance when it is empty.
Never use the appliance with the protection
lid (2) closed.
Set the thermostat to the Maxi position.
Leave to pre-heat the appliance for
10-15 minutes.
On first use, the appliance may smell slightly
and possibly give off smoke for the first few
minutes – this is normal.
Never leave the appliance unattended when
in use.
WARNING: do not use charcoal or any other
combustible material in the appliance.
Cooking
After pre-heating, the appliance is ready to
be used.
Set the thermostat to the position of your
choice.
Leave to cook depending on your taste.
Ensure that there is always water in the
base during the use of the appliance.
If water needs to be added
during cooking, pour it into the
opening (8a) provided for this
purpose at the rear of the base
of the appliance (8).
Do not touch metallic parts while the
appliance is on as they are very hot.
Do not cook food in tinfoil.
Never place aluminium foil or anything else
between the grill plate and the food to be
cooked.
D
D
Grill'n Pack plaque 05/05 24/5/05 14:32 Page 18
19
ENG
Storage
Place the heating element (5) on the
reflector (7) then insert the control panel (6)
properly in its place.
Put the power supply cord (10) in the
compartment provided for this purpose
behind the control panel (6), and then store
it in the reflector (7).
Place the grill plate (4) on the appliance and
lock it in place using the two handles (3).
Put the protection lid (2) back in place by
extending it slightly, taking care to match up
the identical shapes in the hinge axis and
the hole in the lid (9).
* Depending on the model:
• Remove the appliance from the two
supports (*13) and fold up the storage
shelf (*12) as shown in the drawings
-> -> -> .
• Place the storage shelf (*12) upside down
on top of the appliance (opposite of ).
Close the protection lid (2): take hold of the
handle, lift the protection lid (2) and then pull
towards you.
Lock the protection lid in place (2) by sliding
the two locks towards the inside (opposite
of ).
The appliance may be stored vertically.
For U.K. users only :
If you have any problems or queries, please
contact our Customer Relations team on :
HELPLINE 0845 602 1454 – UK
(01) 4751947 – Ireland
This product has been designed for
domestic use only. Any commercial use,
inappropriate use or failure to comply with
the instructions, the manufacturer accepts
no responsibility and the guarantee will not
apply.
J
A/1
F
C
E/1E/2E/3E/4
G
D
H
D
Never put aluminium foil in the reflector.
Do not place cooking utensils to heat on the
appliance.
After use
Never leave the reflector in the water
between each use.
Set the thermostat to the min. position.
Unplug the appliance and let it cool down
before removing the grill plate (4), the
heating element (5) and the reflector (7).
Never close over the protection lid (2) if the
appliance is still hot.
The grill plate (4), the reflector (7), the base of
the appliance (8) and the protection lid (2)
can be cleaned with a sponge, hot water and
washing up liquid.
To remove the grill plate (4), unlock it from
the appliance using the handles (3).
To remove the protection lid (2):
• Take hold of the handle, lift the protection
lid (2) and then incline it towards you.
• When the identical shapes in the hinge
axis and the hole in the lid (9) are opposite
one another, the lid may be removed by
slightly extending the lid towards the
outside.
Do not use a metal scourer or scouring
powder.
To clean the grill plate (4), the sponge can be
replaced by a brush.
The heating element (5) does not need
cleaning.
If it is really dirty, rub with a dry cloth when
cold.
Never immerse the appliance in water with
its heating element and its cord.
D
G
F
D
D
D
D
Grill'n Pack plaque 05/05 24/5/05 14:32 Page 19
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
Tefal BG7030 is a versatile and powerful grill that allows you to enjoy delicious grilled meals indoors or outdoors. It features a large grilling surface, adjustable temperature control, and a water reservoir to prevent flare-ups and ensure even cooking.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- français: Tefal BG7030 Fiche technique
- español: Tefal BG7030 Ficha de datos
Related papers
-
Tefal BG703012 Owner's manual
-
Tefal BG7038 - Grill N Pack Owner's manual
-
-
-
-
-
Groupe SEB USA - T-FAL CB601150 User manual
-
Tefal CB608112 User manual
-
-
Other documents
-
WHITE BROWN S 123 Owner's manual
-
-
George Foreman GRBV5130CUX User guide
-
Charbroil 20602111 Owner's manual
-
Gaggenau VR 414 611 Owner's manual
-
Krups PG760851 User manual
-
-
George Foreman GBR5750SBLQ User manual
-
-
Gaggenau VR 230 620 Owner's manual