Audio Design R1653 Owner's manual

Brand: Audio Design

Model: R1653

Category: Car speakers

Type: Owner's manual

07/2010 E.W.R.

1230-55419-04

Printed in China

Full Range Speakers

Serial Number: Date of Purchase:

Installation & Operation

Installation et fonctionnement

Instalación y funcionamiento

Einbau und Betrieb

Installazione e funzionamento

5.25˝– R152

4˝– R142

6.5˝ – R1653

6˝x 8˝ – R1682

6˝x 9˝ – R1693

Rockford Corporation offers a limited warranty on Rockford Fosgate products on the following terms:

Length of Warranty

Speakers – 1Year. Any Factory Refurbished Product – 90 days (receipt required)

What is Covered

This warranty applies only to Rockford Fosgate products sold to consumers by Authorized Rockford Fosgate

Dealers in the United States of America or its possessions. Product purchased by consumers from an

Authorized Rockford Fosgate Dealer in another country are covered only by that country’s Distributor and

not by Rockford Corporation.

Who is Covered

This warranty covers only the original purchaser of Rockford product purchased from an Authorized

Rockford Fosgate Dealer in the United States. In order to receive service, the purchaser must provide

Rockford with a copy of the receipt stating the customer name, dealer name, product purchased and date of

purchase. Products found to be defective during the warranty period will be repaired or replaced

(with a product deemed to be equivalent) at Rockford's discretion.

What is Not Covered

1.Damage caused by accident, abuse,improper operations, water, theft, shipping

2.Any cost or expense related to the removal or reinstallation of product

3.Service performed by anyone other than Rockford or anAuthorized Rockford Fosgate Service Center

4.Any product which has had the serial number defaced, altered, or removed

5.Subsequent damage to other components

6.Any product purchased outside the U.S.

7.Any product not purchased from anAuthorized Rockford Fosgate Dealer

Limit on Implied Warranties

Any implied warranties including warranties of fitness for use and merchantability are limited in duration to the

period of the express warranty set forth above. Some states do not allow limitations on the length of an implied

warranty,so this limitation may not apply.No person is authorized to assume for Rockford Fosgate any other

liability in connection with the sale of the product.

How to Obtain Service

Contact theAuthorized Rockford Fosgate Dealer you purchased this product from.If you need further

assistance, call 1-800-669-9899 for Rockford Customer Service.You must obtain an RA# (Return

Authorization number) to return any product to Rockford Fosgate.You are responsible for shipment

of product to Rockford.

EU Warranty

This product meets the current EU warranty requirements,see your Authorized dealer for details.

Rockford Fosgate, the Rockford Fosgate logo and the PRIME logo are either

registered trademarks or trademarks of Rockford Corporation.

LIMITED WARRANTY STATEMENT

Designed & Engineered in Tempe, Arizona, U.S.A.

Specifications subject to change without notice.

Cutout

Hole

Example of standard door installation

Before beginning any installation, follow these simple rules:

1. Be sure to carefully read and understand the instructions before attempting to

install these speakers.

2. For safety, disconnect the negative lead from the battery prior to beginning the

installation.

3. For easier assembly, we suggest you run all wires prior to mounting your speakers

in place.

4. Use high quality connectors for a reliable installation and to minimize signal or

power loss.

5. Think before you drill! Be careful not to cut or drill into gas tanks, fuel lines,

brake or hydraulic lines, vacuum lines or electrical wiring when working on any

vehicle. If installation in a boat, take care not to cut or drill through the main hull.

6. Never run wires underneath the vehicle. Running the wires inside the vehicle or

hull area provides the best protection.

7. Avoid running wires over or through sharp edges. Use rubber or plastic

grommets to protect any wires routed through metal, especially the firewall.

1. Determine where the speakers will be mounted. Ensure an area large enough for

the speaker to mount evenly. Be sure that the mounting location is deep enough

for the speaker to fit; if mounting in a door, operate all functions (windows, locks,

etc.) through their entire operating range to ensure there is no obstruction.

2. Refer to the specification chart to determine the proper diameter hole to cut for

your speaker model.The template provided also gives the proper cutout size.

3. Using the template provided, mark the locations for the mounting screws. Drill

the holes with a 1/8" bit.

4. Feed the speaker wires through the cutout and connect to the speaker terminals.

Be sure to observe proper polarity when connecting the wires.The speaker's

positive terminal is indicated with a "+".

5. Fit the trim ring over the speaker and mount into place using four (4) screws.

6. Tighten the screws until the speaker and trim ring are snug in place to prevent

rattling. Do not over tighten the screws.

SAFETY

CARTON CONTENTS

CAUTION: Before installation, disconnect the battery

negative (-) terminal to prevent damage

to the unit, fire and/or possible injury.

PRACTICE SAFE SOUND™

Continuous exposure to sound pressure levels over 100dB may

cause permanent hearing loss. High powered auto sound systems

may produce sound pressure levels well over 130dB. Use common

sense and practice safe sound.

• (1) Set Prime Series Full Range Speakers

• (1) Set of decorative speaker grilles (R142, R152, R1653, R1693)

• Mounting Hardware

INSTALLATION CONSIDERATIONS

MOUNTING

Rear

Deck

Cutout

Hole

Example of

rear deck installation

R1653

• Piezo Super MYLAR Tweeter

• 0.5" Balanced Dome MYLAR Tweeter

• Mica injected polypropylene cone

• Cold Rolled Steel Frame

R1693

• 0.5" Balanced Dome MYLAR Tweeter

• 1.75" Midrange MYLAR Speaker

• Mica injected polypropylene cone

• Cold Rolled Steel Frame

FEATURES

R142, R152 & R1682

• 0.5" Balanced Dome MYLAR Tweeter

• Mica injected polypropylene cone

• Cold Rolled Steel Frame

Specifications subject to change without notice

PRIME R142 R152 R1653 R1682 R1693

Grille Diameter - inch 5.31 6.10 7.01 – 7.56 x 10.20

(mm) (135) (154.6) (178.00) – (192 x 259)

Grille Height - inch 0.51 0.70 0.67 – 1.18

(mm) (13) (17.85) (17.09) – (30.05)

Mounting Diam. - inch 3.67 4.76 5.81 5.08 x 7.32 6.02 x 8.74

(mm) (93.46) (121) (147.5) (129 x 186) (153 x 222)

Mounting Depth - inch 1.64 1.91 2.00 2.54 2.65

(mm) (41.80) (49.5) (51.2) (64.5) (72.4)

PRIME R142 R152 R1653 R1682 R1693

Nominal Diameter - inch 4 5.25 6.5 6 x 8 6 x 9

(mm) (101.6) (133.4) (165.1) (152.4 x 203.2) (152.4 x 228.6)

Description 2-Way 2-Way 3-Way 2-Way 3-Way

Nominal Impedance (ohms) 4Ω 4Ω 4Ω 4Ω 4Ω

Frequency Response (Hz) 100Hz-22kHz 53Hz-22kHz 48Hz-22kHz 57Hz-20kHz 48Hz-22kHz

Voice Coil Diameter - inch 1.0 1.0 1.25 1.05 1.25

(cm) (2.54) (2.54) (3.23) (2.66) (3.23)

Fs - Free Air Resonance (Hz) 110 Hz 74 Hz 67 Hz 73 Hz 66 Hz

Qts 1.07 0.91 0.78 1.03 0.81

Vas - cu. ft. 0.05 0.27 0.53 0.44 0.64

(Liter) (1.48) (7.6) (14.9) (12.4) (18.0)

Xmax - inch 0.07 0.13 0.17 0.30 0.20

(cm) (0.19) (0.34) (0.43) (0.76) (0.51)

SPL (dB @ 1w/1m) 85.5dB 87dB 89dB 88dB 90dB

Power Handling-Watts 25W RMS 35W RMS 40W RMS 50W RMS 60W RMS

50W MAX 70W MAX 80W MAX 100W MAX 120W MAX

PHYSICAL DIMENSIONS SPECIFICATIONS

6.48"

(164.5mm)

10.20"

(259.0mm)

8.74"

(222.00mm)

2.85"

(72.40mm)

3.89"

(98.85mm)

4.78"

(121.5mm)

7.56"

(192.0mm)

6.02"

(153.00mm)

4.57"

(115.96mm)

5.81"

(147.50mm)

2.0"

(51.20mm)

2.69"

(68.35mm)

4.76"

(121.00mm)

1.91"

(48.50mm)

0.70"

(17.85mm)

0.51"

(13.00mm)

0.67"

(17.09mm)

1.18"

(30.05mm)

2.47"

(62.85mm)

3.83"

(97.23mm)

6.10"

(154.6mm)

R152R142 R1653

R1693

R1682

2.54"

(64.50mm)

8.00"

(203.00mm)

5.08"

(129.00mm)

5.00"

(127.00mm)

5.71"

(145.00mm)

7.32"

(186.00mm)

4.25"

(108.00mm)

6.10"

(154.8mm)

3.26"

(82.94mm)

3.26"

(82.94mm)

5.31"

(135mm)

5.41"

(137.5mm)

7.01"

(178.00mm)

7.00"

(178.0mm)

6.46"

(164.00mm)

10.20" x 7.56"

(259.0mm x 192.0mm)

1.64"

(41.80mm)

2.16"

(54.90mm)

3.67"

(93.46mm)

Page is loading ...

1.00"

(25.40mm)

Verify Scale

Before Using

Template

1.00"

(25.40mm)

6.46"

(164.0mm)

R1653

Mounting

Holes

Mounting Holes

5.81"

(147.5mm)

R1653 Hole Cutout

3.67"

(93.46mm)

3.26"

(82.94mm)

R143 Hole Cutout

SPEAKER MOUNTING TEMPLATE

1.00"

(25.40mm)

Verify Scale

Before Using

Template

1.00"

(25.40mm)

7.32"

(186.00mm)

5.08"

(129.00mm)

R1682

Hole

Cutout

SPEAKER MOUNTING TEMPLATE

6.48"

(164.5mm)

4.76"

(121.0mm)

5.41"

(137.5mm)

4.78"

(121.5mm)

1.00"

(25.40mm)

Verify Scale

Before Using

Template

1.00"

(25.40mm)

R152

Mounting

Holes

R1693

Mounting

Holes

R152 Hole Cutout

6.02" x 8.74"

(153.0mm x 222.0mm)

R1693 Hole Cutout

SPEAKER MOUNTING TEMPLATE

Audio Design R1653 Owner's manual

Brand: Audio Design

Model: R1653

Category: Car speakers

Type: Owner's manual

Download PDF

report

in other languages

italiano: Audio Design R1653 Manuale del proprietario
français: Audio Design R1653 Le manuel du propriétaire
español: Audio Design R1653 El manual del propietario
Deutsch: Audio Design R1653 Bedienungsanleitung

Audio Design R1653 Owner's manual

Audio Design R1653 Owner's manual

in other languages

Related papers

Other documents