Please read these
instructions carefully before
you use your device for the
first time.
Retain these user
instructions for future
reference.
1
Pour the required
amount of water into the
bottom glass jug.
2
Then place the jug
either on an electric, gas
or methylated spirits stove.
The glass jug may not be
wet on the outside. For gas
stoves we recommend that
you use a heat diuser.
3
Now insert the filter in
the funnel.
4
There is a small chain on
the filter with a hook. Pull
the chain gently and secure
the hook to the edge of
the tube.
5
Place the ground coee
in the funnel. Use one scoop
of coee for each cup. Any
grind of coee can be used.
6
Now place the funnel on
the jug and bring the water
to a boil.
7
The water in the jug will
now rise into the funnel
and mix with the ground
coee. Around 2 cm of
water will remain in the
glass jug at the bottom.
(If no water remains in the
jug, it must be removed
from the heat immediately
and then replace since
there is a risk that it will
crack from the heat).
Instructions for use
English
8
Now take the coee o
the heat and place it on a
surface which is neither
cold nor wet. The coee is
now “brewed”, the coee
should now pass into the
lower jug. Should it cease
to fall into the jug simply
replace onto the heat and
bring to the boil again.
9
As soon as the coee
has run out of the funnel
into the jug, remove the
funnel. The coee is now
ready to drink. Clean the
funnel by removing the
coee grinds, releasing
the filter hook from the
glass tube and rinsing both
thoroughly.
Instructions for use
English