Broadcom OneConnect-OCE-ER120
5
OneConnect Errata Documentation Updates
2.2.1 Updated Operating System Support
ESX 6.7 operating system support has been added to the RT 12.0 software release.
2.2.2 Resolved Issues
The following VMware driver issues have been resolved in this release:
Added ESX67 IMA Plugin support.
Failed to discover LUNs using IMA plugin in ESXi 6.7 after iSCSI target login.
VMs looses network connectivity:
This release of elxnet resolves an issue seen under ESX 6.0 releases with elxnet version 11.2 (and to a lesser extent on
elxnet 11.1.xxx) where just one or more VMs on a ESX host would lose connectivity to network entities external to the
ESX host, but would continue to be able to communicate to other VMs on the same ESX host. Also in this scenario, other
VMs on the same ESX host would continue to function normally. Choices to recover were to either vMotion the affected
VM/s to another host or reboot the ESX host.
Elxnet regression where ping failed in VXLAN environment.
ESXi 6.6 system not booting up after OOB NIC driver install.
Adopted vmk_DeviceGetParamMaxVfs to get the maximum number of VFs from a PCI device.
Enforced TX completion budget.
ESX 6.7 sfcb is crashing every 2 minutes when connected to Win OCM.
2.3 Windows Driver Updates
This section discusses updates to the OneConnect drivers.
2.3.1 Windows 10 Client OS Support
The Windows 10 Client OS is no longer supported with the RT 12.0 software release from this version of software on.
2.3.2 Known Issues
The Windows 2016 SRIOV event viewer error message, Drive is not ready for use, its door may be open. This message can
be ignored.
2.3.3 Resolved Issues
The following Windows driver issues have been resolved in this release:
Clear the Bus Master DMA when the firmware IOCTL times out to prevent DMA from happening for already freed
memory.
Occfg.exe is now vendor signed.