promethean ActivPanel Stand Installation guide

Category
Flat panel wall mounts
Type
Installation guide
2
3
5
4
6
Remove cover from the stand Lock the stand with lock screws Level vertically with feet at the bottom
Make sure screws are unlocked Lift the stand onto the bracket
4 x M3.5
1x
1x
1x
Optional
Safety warnings, contents of the box, tools needed
Installation should only be performed by a Qualified Installation Professional
1
Mount wall bracket level to the wall
*Fasteners not included.
Please use the relevant fasteners for the type
of wall to be installed on.
For non-load bearing wall use APTFSBB400
floor Support (Not included)
ActivPanel Adjustable Stand 400
Installation Guide
ActivPanel Adjustable Stand 400
APTASBB400-70 - for use with ActivPanels™ with a mass* of 41kg to 70kg
Installation Guide
TP-1940-V05 ©2016 Promethean Ltd. All Rights Reserved. Products are subject to availability by country.
Product specifications are subject to change without notice.
x4
12
16
12
16
2x
ActivPanel Adjustable Stand 400
APTASBB400-70 - for use with ActivPanels™ with a mass* of 41kg to 70kg
Installation Guide
TP-1940-V05 ©2016 Promethean Ltd. All Rights Reserved. Products are subject to availability by country.
Product specifications are subject to change without notice.
TP-1940 -V05
9
Set Balance, Use Drill Driver Left/Right 5 Sec Counter Clockwise Until Balanced
support.prometheanworld.com
8
4 x M8
Max 10 mm
Mount Wall Cover
7
(Vesa mount shown but not included).
When mounting the
ActivPanel use
APTVMBB400 for APT2/3
variants
For APT4 onwards use the
mount included with the
panel.
Attach the side guards to the stand using the
Vesa mount installation points shown above.
*Total mass of ActivPanel, VESA mount and any accessories attached to the ActivPanel™
  • Page 1 1
  • Page 2 2

promethean ActivPanel Stand Installation guide

Category
Flat panel wall mounts
Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI