ENGLISH
2
IMPORTANT SAFETY
INSTRUCTIONS
When using an electrical appliances, basic precautions should
always be followed, including the following:
READ ALL INSTRUCTIONS
BEFORE USING THIS
APPLIANCE.
WARNING: To reduce the risk of fire,
electric shock, or injury:
a ) Do not use outdoors or on wet surface
b ) Do not allow to be used as a toy. Close attention is
necessary when used by or near children.
c ) Use only as described in this manual. Use only
manufacturer’s recommended attachments.
d ) Do not handle appliance with wet hands.
e ) Do not put any object into openings. Do not use
with any opening blocked; keep free of dust, lint, hair,
and anything that may reduce air flow.
f ) Keep hair, loose clothing, fingers, and all parts of body
away from openings and moving parts.
g ) Use extra care when cleaning on stairs.
h ) Do not use to pick up flammable or combustible
liquids, such as gasoline, or use in areas where they
may be present.
i ) Do not pick up anything that is burning or smoking,
such as cigarettes, matches, or hot ashes.
j ) Do not incinerate the appliance even if it is severely
damaged. The batteries can explode in a fire.
ADDITIONAL SAFETY WARNINGS
a ) Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type
of battery pack may create a risk of fire when used
with another battery pack.
b ) Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally
occurs, flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid ejected from
the battery may cause irritation or burns.
c ) Do not use a battery pack or appliance that
is damaged or modified. Damaged or modified
batteries may exhibit unpredictable behavior resulting
in fire, explosion or risk of injury.
d ) Do not expose a battery pack or appliance to
fire or excessive temperature. Exposure to fire or
temperature above 266°F (130°C) may cause explosion.
e ) Have servicing performed by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the product is maintained.
WARNING: Do not attempt to modify or
repair the appliance
NOTE: This appliance is intended for household use only and
should not be used for commercial purposes.
Prevent unintentional starting. Ensure the switch is in the
off-position before connecting to battery pack, picking up
or carrying the appliance. Carrying the appliance with your
finger on the switch or energizing appliance that have the
switch on invites accidents .
Follow all charging instructions and do not charge the battery
pack or appliance outside of the temperature range specified
in the instructions. Charging improperly or at temperatures
outside of the specified range may damage the battery and
increase the risk of fire.
Only for use with S003AQU1500015 charger.
SAVE THESE
INSTRUCTIONS
The label on your tool may include the following symbols. The
symbols and their definitions are asfollows:
V ......................... volts
Hz .......................hertz
min ..................... minutes
or DC ......direct current
...................... Class I Construction
(grounded)
…/min ..............per minute
BPM ....................beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................watts
or AC ...........alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n
o
.......................no load speed
n .........................rated speed
......................earthing terminal
.....................safety alert symbol
.....................visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
Assembly - Fig. B
1. Slide the lower pole
5
into the sweeper head pole
6
.
Ensure the slot of the lower pole is on the top.
2. Slide one of the middle poles
4
into the lower pole.
Ensure the nub of the middle pole lines up with the slot
of the lower pole.
3. Slide the second middle pole into the first. Ensure the
nub of the second middle pole lines up with the slot of
the first middle pole.
4. Slide the handle
3
into the second middle pole
4
.
Ensure the nub of the handle lines up with the slot of
the middle pole.