Hardwood Reflections 54224PDBWHUB-60 Installation guide

Brand
Hardwood Reflections
Model
54224PDBWHUB-60
Type
Installation guide
Thank you for choosing The Power Driven Work Station.
This product will be an integral part of your life with an
array of applications in garages, laundry rooms, kitchens,
and anywhere you need extra work space.
InstructIon Manual &
asseMbly InstructIons
to reduce the rIsk of severe Injury or death:
• READ AND FOLLOW ALL DIRECTIONS
• Never apply more force than the products
published load limit
• Do not make any modifications to the product
• Never operate unless bench is properly installed
• Never allow children to operate or play on or
around bench
WarnIng
the PoWer drIven Work statIon’s caPacIty Is
800 lbs. of statIc load evenly dIstrIbuted over
the toP of the butcher block countertoP.
the bench Must be asseMbled ProPerly to
PerforM correctly and be able to suPPort
the rated caPacIty.
THE MULTI-TASK WORKBENCH
asseMbly requIres tWo PeoPle to lIft the
butcher block toP and fasten It In Place.
asseMbly tIMe should take less than 45-MInutes.
45
MIn
work
STATION
work
POWER DRIVEN
TM
1
3
steP
steP
asseMble the base
add accessorIes
• Use the 5/8" bolts to
attached back brace to both
legs making sure to place
triangle shapes on cross
braces towards the outside
• Set in your bottom 15
3
/
4
" x 52" butcher
block shelf on the cross braces
asseMbly InstructIons
tools (not included)
• Drill with Phillips Bit
• Phillips Screwdriver
• 5/8" wrench
• 6 - AAA batteries
hardWare (included)
QTY DESCRIPTION
2 Leg Assemblies with Feet
1 Back Brace
4 5/8" Bolts
2 LED Light Assemblies
8 3/4" Wood Screws
8 1" Wood Screws
1 60" x 24" Butcher Block Top
1 15
3
/
4
" x 52" Butcher Block Shelf
1 Power Strip
tools & MaterIals needed
• Center the 60" x 24" butcher block top
onto the top of the leg assembly
• Secure the top with the 1" screws through
the 8 - pre-drilled
holes in the leg
assembly
• Remove two screws from each
LED light assembly to release the
mounting bracket for the lights
• Use 3/4" wood screws to mount
the LED mounting brackets to the
butcher block top in the location that
works best for your needs
• Place 3-AAA batteries (not included)
in the base of each LED light
2
steP add bench toP
• Place LED light on mounting bracket
and re-secure the LED lights using the
screws that were previously removed
• Use remaining 3/4" wood screws to
mount the power strip onto the wood
top, also in the location that works best
for your needs
• Now that your bench is assembled,
use the four adjustable feet to level
and stabilize the bench
  • Page 1 1
  • Page 2 2

Hardwood Reflections 54224PDBWHUB-60 Installation guide

Brand
Hardwood Reflections
Model
54224PDBWHUB-60
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents