Screen Tight WSKIT51648 Operating instructions

Brand
Screen Tight
Model
WSKIT51648
Type
Operating instructions
BUILD-A-SCREEN
HOW TO BUILD A WINDOW SCREEN FRAME
Measuring Tape Hack Saw Screen Rollerknife
How to Build & Install
Access Videos & Resources at ScreenTight.com
One Better Way • Georgetown, SC 29440 • 800.768.7325
1
4
2
5 6
3
Measure
Measure the height & width of
the window opening where the
frame will be installed.
Assemble
Insert corners into frames using
the screen frame fastener verti-
cal pieces rst, then attach each
vertical piece to the horizontals.
Mark
Mark Aluminum frames to
height (H-1 1/2”) & width
(W-1 1/2”) Each corner
adds 3/4”.
Install Hardware
Place pull tabs as desired and
install any other additional
hardware such as a plunger
bolt or loop and latch.
Roll Screen & Trim
Roll Screen into spline groove
with .160 spline. Spline will
hold in hardware. Trim excess
screen with Utility knife or
blade from Rollerknife.
Cut
Cut marked pieces with
hacksaw. If your frame
exceeds 3 feet in height, cut
an additional (W-1 1/2”) for
use as a cross brace.
Tools &
Supplies
ScreenTight.com
  • Page 1 1

Screen Tight WSKIT51648 Operating instructions

Brand
Screen Tight
Model
WSKIT51648
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents