House of Fara W96WP Operating instructions

Type
Operating instructions

This manual is also suitable for

Vinyl Wainscot/Planking Instructions
Install and level matching base board.
Apply bead of paneling adhesive to the back of trim
Nail trim into studs 16 inch on-center
Cut plank to measured height.
Apply bead(s) of paneling adhesive to the back of panel.
Stick panel at wall placement into base groove, neatly place panel groove over adjacent panel’s tongue.
Level panel to ensure vertical.
Cap and level with matching chair rail.
Apply bead of paneling adhesive to the back of trim
Stick trim on top of panels, with grove for panels facing down
Level trim to ensure horizontal
Nail trim into studs 16 inch on-center
Apply bead of caulk along top, inner edge of trim
MAINTENANCE: Wipe with Damp cloth. Most household cleaners will not affect the finish; it is recommended to test
cleaners in small unseen areas prior to using on entire surface. If painted, follow the paint manufacturer’s instructions
for cleaning.
Complete instructions are on back side of package labels.
  • Page 1 1

House of Fara W96WP Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI