1

For technical questions call: 1-800-665-8685

V 2.0 8387714

30 pc Wall

Mounted

Storage Bins

SPECIFICATIONS

Removable polypropylene plastic bins hang on polypropylene board

18 small red bins: 3-1/2" x 4" x 2"

this manual refers to a part number, it refers to the parts list included. Before allowing someone else to use this

tool, make sure they are aware of all safety information.

SPECIFIC SAFETY PRECAUTIONS

1. This product is not a toy. Do not allow children to play with or near this item.

2. Use for intended purpose(s) only.

3. Inspect before use; do not use if parts are loose or damaged.

4. Maintain product labels and nameplates. These carry important safety information. If unreadable or missing,

contact Princess Auto for a replacement.

INSTALLATION INSTRUCTIONS

WARNING! Read the entire important safety information section at the beginning of this document including all

mounting holes.

4. After checking the mounting area for hidden wiring, drill the 8 holes to hold 1/8" wood screws

a. These screws must be at least 2" long.

5. Mount the Panel Board (3) to the wooden surface with 8 wood screws. (Not supplied)

a. All 8 Wood screws must be screwed into the solid wooden surface.

6. Bins mount onto the Peg Panel Board by hanging the back lip of the Bins on the open slot of the

Panel Board. The smaller Bins (1) mount in the upper 3 rows and the larger Bins (2) in the lower 2 rows

(See Fig.1.)

30 pc Wall Mounted Storage Bins

2

WARNING! If any part is missing, do not operate the tool until the missing parts are replaced. Failure to do so

could result in serious personal injury.

CLEANING AND MAINTENANCE

1. Before each use, inspect the condition of the Bins and Peg Panel Board (3). (See Fig 1.)

a. Check for cracks and splits or any other broken part.

b. Make sure the Peg Panel Board has not loosened from the wall.

2. When necessary, clean the Bins with a damp cloth or shop towel.

PARTS BREAKDOWN