2. Fringe sport
  3. V2 DOUBLE WALL BALL TARGET
V2 DOUBLE WALL BALL TARGET

Fringe sport V2 DOUBLE WALL BALL TARGET User guide

  • Hello! I've reviewed the user manual for the FRINGE SPORT Wall Ball Target V2 DOUBLE. This document provides detailed step-by-step instructions for assembling the target, highlighting the specific order to tighten the nuts and bolts. I'm ready to answer any questions you might have about the assembly process or use of this product.
  • What tools are needed for assembly?
    What is the first step in assembly?
    What should be done after sliding the carriage bolt?
SLIDE CARRIAGE BOLT
THROUGH THE PLATE AND
POST. SLIDE THE NUT
THROUGH POST. LIGHTLY
SCREW THE NUT ONTO
THE CARRIAGE BOLT
TURN THE PLATE FLAT ON
THE GROUND AND
TIGHTEN THE LOWER
CARRIAGE BOLT NUT
FIRST.
TURN THE POST ON ITS
SIDE, PRESS ON THE
HEAD OF THE CARRAIGE
BOLT AND TIGHTEN THE
NUT.
SLIDE THE BOLT THOUGH
UPRIGHT THROUGH THE
UPRIGHT AND THE NUTS
THE POST AND TIGHTEN.
MATCH UP THE SQUARE
HOLES, SLIDE THE
CARRIAGE BOLTS
THOUGH THE SQUARE
HOLES AND TIGHTEN THE
NUTS FROM BEHIND.
WALL BALL TARGET V2 DOUBLE
TOOLS NEEDED :
#17 Wrench 5/8” Hardware
/