Charging The Base
With the included USB/micro-USB cable: insert the micro-USB
end into port 'A' of the charging case, and the USB end into a
PC or travel charger port. The blue LEDs inside the case (B) will
illuminate in sequence to indicate progress of charging.
Charging the ear buds
Place both earbuds in the charging case: the LEDs will
illuminate fixed red to indicate that charging is in progress.
When charging is complete they will temporarily turn blue and
then turn off.
Activation and pairing
Make sure you have turned off Bluetooth on your smartphone.
Hold down the MFB button (the only button on the earbuds)
for a few seconds, until both LEDs flash red and blue alternate-
ly. Wait a few seconds until the ear buds recognize and pair
with each other (this will be confirmed by the voice message:
'connected'). Only at this point, activate Bluetooth on your
smartphone. As soon as the pair of earbuds is recognized,
select (iGear-BumbleBee) from the list: the LEDs will turn off to
confirm successful pairing. If only one earbud has been paired
by mistake, unpair it and repeat the procedure from scratch.
After the first connection, the earbuds will automatically pair
on removing them from the charging case.
Power off
Press and hold the MFB buttons until the LED flashes red once
to indicate power off or insert the earbuds into the charging
case and close it.
1
