2. Razor
  3. W25143499112
W25143499112

Razor W25143499112 User manual

  • Hello! I've reviewed the installation instructions for the Razor Safety Button W25143499112. This document provides a detailed, step-by-step guide for replacing the safety button and includes instructions for disassembly and reassembly. I am ready to assist with any questions you may have about the installation process!
  • What tools are needed for the safety button installation?
    What should I do before starting the installation?
    What is the first step of the instruction?
WARNING
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM PST.
1
Tools Required: (Not included)
A. 5 mm Allen wrench
B. 10 mm wrench
C. Phillips screwdriver
D. Flathead screwdriver
Step 1
Figure 1a Figure 1b
Using a 5 mm Allen wrench, loosen the four (4) hex
bolts that attach the seat to the frame (Figure 1a)
and remove seat. Remove the two (2) hex bolts on
the Drift Bar cover (Figure 1b) and remove.
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger
before removing or installing the safety button. Failure to follow these steps in the correct order may
cause irreparable damage.
Step 2
Figure 2a Figure 2b
Using a 5 mm Allen wrench and a 10 mm wrench,
loosen the two (2) hex bolts on the side of the
battery cover (Figure 2a) and the two (2) locknuts,
located underneath the unit (Figure 2b).
CRAZY CART
SAFETY BUTTON
INSTALLATION INSTRUCTIONS
W25143499112
Step 7
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM PST.
2
Step 3
Figure 3
Remove the battery cover by lifting up the right side
first then slide off. Be careful not to pull any of the
wires that are attached to the cover.
Step 4
Figure 4a Figure 4b
Locate the white plastic connector on the charger port
that attaches to the control module and disconnect by
depressing the tab on the connector (Figure 4a). Using a
small pointed object, carefully depress the two (2) locking
pins inside the white plastic connector attached to the
safety button and remove the connector (Figure 4b).
Step 5
Figure 5
Using a Phillips screwdriver, loosen the four (4)
screws on one (1) side of the motor cover and
remove cover.
Step 6
Figure 6
Using a flathead screwdriver, carefully remove the
silicone from the back of the safety switch. Push the
safety button through the opening (see inset) and
remove from unit.
Reverse steps 1 through 6 to install replacement safety button.
ATTENTION: Charge battery 12 hours before initial use.
140124
/