2. RC Factory
  3. T51-52
T51-52

RC Factory T51-52 User manual

  • Hello! I've reviewed the Termik user manual which provides a comprehensive step-by-step guide on how to assemble your new plane. This includes clear instructions for applying glue, covering, and putting all of the components together. I am ready to assist you with any queries or uncertainties you might have during your assembly process.
  • What temperature should be used for ironing the covering film?
    What kind of glue should be used?
    What are the dimensions of the plastic bowdens?
Termik
1.
3.
5.
7.
2.
4.
6.
8.
Medium CA
Remove the supports by screwdriver
12x480mm
10x295mm
L+R
L+R prepared for the foil covering
use covering film 38 mic with iron on 145°C
Activator
Medium CA
9. 10.
11. 12.
13. 14.
15. 16.
Medium CA
50mm
Thin CA
you can cover the join by foil
Medium CA
horns for ailerons
Medium CA
screw the bolt to the lever inwards!
screw the bolt to the lever outwards!
17. 18.
19. 20.
21. 22.
23.
Thin CA
3x0,5x250
plastic bowden 630mm
1x850mm
L+R
Thin CA
Medium CA
plastic bowden 60mm
3x0,5x250
plastic bowden 630mm 1x850mm
90mm
Click it!
The wing is ready!
Medium CA
24. 25.
26. 27.
28. 29.
30. 31.
Thin CA
Medium CA
use pliers for the 4mm nut
be careful whether it is in the same line
Medium CA
Medium CA
32. 33.
34. 35.
36. 37.
38. 39.
use pliers for the 4mm nut
Medium CA
this hole to the tail
put the servos in the fuselage
2nd
1st
Thin CA
all parts are ready for foil ironing
do not leave the places that will be glued covered with foil
higher horns put in the holes
Medium CA
Medium CA
0,8x770mm
40. 41.
42. 43.
44. 45.
46. 47.
Medium CA
Medium CA Medium CA
0,8x740mm
put the carbon in bowden
click it
Thin CA
The first step to glue the rudder to elevator
The second step glue the tail to the fuselage
put the heatshrink!
Medium CA
put the heatshrink!
Thin CA
48. 49.
50. 51.
52. 53.
54.
put the carbon in bowden
click it
1st hole for the rudder
2nd hole for the hook
90mm iron for the hook
be careful on the correct polarity of magnets
Thin CA
Thin CA
squeeze with pliers!
squeeze with pliers!
Battery Reciever
BEC
60mm
We wish you many happy flying hours with the Termik.
Your RC Factory team
/