SHELF-MADE RP-201HR-68ANT Installation guide

Hello, I'm your chat assistant. I have reviewed this user manual for shelf bracket installation. I understand it describes the tools and step-by-step instructions for successfully mounting shelf brackets, including how to locate studs, use a level, and securely fasten the brackets and the shelf. I am ready to answer any questions you may have about this process or the materials needed.
What tools are needed for shelf bracket installation?

How do I locate wall studs?

How do I ensure the brackets are level?

What should I do after placing the shelf on the brackets?

What should I do if I have missing parts or installation issues?

Shelf Bracket Installations

Tools needed for installation:

In order to install the shelf brackets you will need a few tools and supplies: a stud finder, level, cordless drill with a bit or screw driver, a pencil,

a shelf and at least two shelf brackets.

Installation:

1) Determine the location on the wall.

2) Locate wall studs and mark them.

3) Use a level and place it at the height you wish to install your shelf and then mark where the top of it crosses the stud center marks.

4) Take your first bracket and place it so that the bracket lines up with center of the stud and the bottom of the horizontal mark

is just above the top of your bracket surface.

5) Fasten the bracket to the wall through the top hole.Then take your level and align the bracket vertically and fasten the bracket securely

to the stud through the remaining screw holes using the wall screws.

6) Repeat the same process for the next bracket.

7) Place your shelf on the brackets and center it for maximum support.

8) Fasten the shelf to the brackets.