SHELF-MADE RP-201RC-8BRZ Installation guide

Brand
SHELF-MADE
Model
RP-201RC-8BRZ
Type
Installation guide
Shelf Bracket Installations
Tools needed for installation:
In order to install the shelf brackets you will need a few tools and supplies: a stud finder, level, cordless drill with a bit or screw driver, a pencil,
a shelf and at least two shelf brackets.
Installation:
1) Determine the location on the wall.
2) Locate wall studs and mark them.
3) Use a level and place it at the height you wish to install your shelf and then mark where the top of it crosses the stud center marks.
4) Take your first bracket and place it so that the bracket lines up with center of the stud and the bottom of the horizontal mark
is just above the top of your bracket surface.
5) Fasten the bracket to the wall through the top hole.Then take your level and align the bracket vertically and fasten the bracket securely
to the stud through the remaining screw holes using the wall screws.
6) Repeat the same process for the next bracket.
7) Place your shelf on the brackets and center it for maximum support.
8) Fasten the shelf to the brackets.
Installation is complete.
For missing parts or installation issues contact:
Customer Service: 1.800.253.1561
[email protected]
  • Page 1 1

SHELF-MADE RP-201RC-8BRZ Installation guide

Brand
SHELF-MADE
Model
RP-201RC-8BRZ
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents