Atlona KIT-PROHD3 User manual

Type
User manual

This manual is also suitable for

atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
Panel Guide
IN port: The Micro USB port is used to recharge the AT-BAT-DIS7PRO. Connect to a PC or wall port
to charge. Depending on the start level, it can take 3 to 4 hours to fully recharge the battery.
Power button: Press once to turn AT-BAT-DIS7PRO on. Pressing a second time will display the
current power level on the back panel LEDs.
NOTE: The power button will not turn off the battery. The AT-BAT-DIS7PRO will auto turn off after
30 seconds of no connection.
OUT Port: Use this port to power other devices such as AT-DIS7-PROHD or AT-HD800
Power: Green LED will light up when power is on. LED will
be off while battery is recharging.
25%: Red LED will light up when checking power if at
least 1% power is remaining.
50%: Red LED will illuminate if at
least 26% power is left in the
AT-BAT-DIS7PRO
75%: Red LED lights up when at least
51% power is remaining.
100%: will light up when the
AT-BAT-DIS7PRO has at least 76%
power remaining.
NOTE: LEDs will blink while charging until the next
power level is reached, then it will go solid.
Ex. 25% will go solid at 26% and 50% will start blinking.
Clip to a pocket and go. The fully portable
AT-BAT-DIS7PRO is a rechargeable
accessory for the AT-DIS7-PROHD and
AT-HD800, allowing them up to 4 hours
of use.
Atlona 4 Hour Portable Battery
AT-BAT-DIS7PRO
LED Guide
  • Page 1 1

Atlona KIT-PROHD3 User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI