Installation instructions for the
DG 155 and
DG 163
Steam ovens
It is essential to read these
operating instructions before
ö]
installing or using the machine,
to avoid the risk of accident
or damage to the machine. M.-Nr. 05 229 050
Contents
General Notes. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Appliance and cut out dimensions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Installation in tall cabinetry. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Installation under a counter top . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Installation above a Miele oven . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Installing the oven . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Securing the oven . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Conversion table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Electrical connection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Important - Save for the local electrical inspector’s use
Contents
2
General Notes
Installation
This steam oven is designed for installa-
tion in cabinetry or beneath a counter
top.
Keep these installation instructions in a
safe place and pass them on to any fu-
ture user.
Illustrated dimensions are in mil-
limeters. For converting to inches, use
the enclosed table.
General Notes
3
Appliance and cut out dimensions
Installation in tall cabinetry
b
Steam oven
c
Cabinet opening
d
Terminal block
e
Outlet or junction box. This should
be accessible after the appliance
has been installed.
f
Power supply cord
456
450
595
560-568
330
22
b
c
d
f
e
min.330
547
447
100
Appliance and cut out dimensions
4
Appliance and building-in dimensions
Installation under a counter
top
b
Steam oven
c
Cabinet opening
d
Terminal block
e
Outlet or junction box. This should
be accessible after the appliance
has been installed.
f
Power supply cord
456
595
560-568
330
22
c
d
f
b
e
450
min.370
547
447
Appliance and cut out dimensions
5
Appliance and building-in dimensions
Installation above a Miele oven
b
Steam oven
c
Cabinet opening
d
Terminal block
e
Outlet or junction box. This should
be accessible after the appliance
has been installed.
f
Power supply cord
g
Oven
Note:
The steam oven must be supported
by ledges or shelving. It must not
rest directly on top of the oven.
560-568
450
593-595
560
560-568
min.330
100
547
22
330
595
550
22
580
547
456
596
595
447
b
g
c
c
d
e
f
Appliance and cut out dimensions
6
Installing the oven
Securing the oven
After aligning the oven it must be se-
cured in position.
Open the oven door and using the sup-
plied screws
h
, secure it to the
cabinet through the holes on either side
of the vertical oven trim.
Conversion table
mm inches
22 7/8
100 3 15/16
330 13
370 14 9/16
447 17 3/4
450 17 11/16
456 17 15/16
547 21 9/16
550 21 11/16
560 22 1/16
568 22 3/8
580 22 13/16
593 23 3/8
595 23 7/16
596 23 1/2
Installing the oven
7
All electrical work should be performed
by a licensed electrician, in strict ac-
cordance with national and local safety
regulations and standards.
Note to installer:
Please leave these instructions with
the consumer.
Power supply:
Please check the dataplate for verifi-
cation of:
240 VAC; 60 Hz
15A, 240 V
L1, L2, Ground
Caution:
Disconnect main power supply be-
fore servicing. To reduce the risk of
electrical shock, make sure that the
appliance is properly grounded
after installation.
WARNING : THIS APPLIANCE
MUST BE GROUNDED
For USA only
The appliance is provided with 3 termi-
nal leads, 1 black wire (L1), 1 red
wire (L 2) and 1 green wire (GND)
which have to be connected to a dedi-
cated junction box. Connect the black
wire to L1, the red wire to L2 and the
green wire to GND.
ALSO SEE THE WIRING DIAGRAM
PROVIDED WITH THE APPLIANCE.
For CDN only
The appliance is provided with 3 termi-
nal leads: 1 black wire, 1 red wire and
1 green wire which have to be con-
nected to a separate overcurrent pro-
tection device (fusebox or circuit
breakers).
All hot wires (black and red) have to be
fused individually before connecting
them to the main power supply leads.
Use 15 Amp fuses or circuit
breakers for appliances rated 240
VAC.
Connect black terminal wire to
L1 (black) and red terminal wire to
L2 (red). The green terminal wire
(ground) has to be connected directly
to the equivalent colored power supply
leads.
All connections must be done in a
proper way.
ALSO SEE THE WIRING DIAGRAM
PROVIDED WITH THE APPLIANCE.
Installing the oven
8
9
10
11
Alteration rights reserved 00/3599
These instructions are printed on 100% recycled paper and are completely Biodegraable.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Miele DG 155-1 User manual
-
-
-
-
-
-
-
-
-
Other documents
-
De Dietrich DOP1145B Owner's manual
-
De Dietrich 6H-580BTCX Owner's manual
-
Electrolux EMS26415W Datasheet
-
AEG HK854400FB User manual
-
Zanussi ZEI6840FBA Datasheet
-
Zanussi EFB60X Datasheet
-
York ECO HFC-410A User manual
-
Johnson Controls NexusPremier 25 Ton Technical Manual
-
-
Groupe Brandt DME1145W3 Owner's manual
