Page is loading ...
5
SPECIFICATIONS :
SENSIBILITE/IMPEDANCE :
DJ/MICRO 3mV/1 Kohms
PHONO 3mV/51 Kohms (RIAA)
CD/LIN 150mV/100 Kohms
NIVEAU DE SORTIE :
MASTER (sortie maxi 8V) 775mV/600ohms asymétrique
REC (Sortie maxi 8V) 380 mV/600 ohms
PHONES (Sortie maxi 420 mV) 380 mV/80 ohms
REPONSE EN FREQUENCE : 20 Hz≈20KHz±0.5dB
(RIAA±2dB)
DISTORTION HARMONIQUE TOTALE 0.01%
SEPARATION STEREO > 45dB
RAPPORT SIGNAL/BRUIT:
DJ MIC 80dB
PHONO 70dB
CD/LINE 85dB
CONTROLE DE TONALITE :
Boost/cut@center Frequency ±12dB@100Hz, 1K, 10 KHz
DIMENSIONS 310 x 236 x 107mm
POIDS 3,4Kg
6
1. MICrophone Input:
A Combination XLR & 1/4“ jack sockets mounted on the front face of
the mixer for connecting your microphone and offer both balanced or
unbalanced microphone connections.
2. MASTER Level:
This rotary control sets the level present at the MASTER unbalanced
RCA jack outputs.
3. DJ Channel LEVEL Control:
Controls the overall level of the DJ channel being mixed onto the
Master outputs.
4. GAIN Controls:
Correct setting of the controls for input Gain for every channel is
crucial for getting a good, strong signal without noise or distortion.
5. Channel Level Control
:
The channel fader adjusts the overall volume of the channel. The
faders of the stereo channels control both left and right signal at
same time.
6. Crossfader ASSIGN Switch
:
Any of the four music channels can be assigned to either side of the
crossfader by the setting of these switches.
NOTE: If the same channel is assigned to both sides of the crossfader
at either extreme that channel will be muted but the channel will be
live when the crossfader at it’s center position. This setting can give
the effect of ‘fader dub fading’ when crossfader is used from it‘s
center to either extreme.
7. Removeable CROSSFADER:
This 45mm crossfader is fully assignable to any of the four main music
channels set by the ASSIGN switches.
8 PHONES:
This is a 1/4” stereo jack socket mounted on the front face of the
mixer for you to attach your headphones.
9. CUE Switch
:
This switch determine which source is heard in the headphones.
10. Headphone LEVE Control:
This control varies the volume in your headphones, the volume of the
signal heard through the headphones.
7
11. Power Switch:
This switches the AC power to the mixer ON or OFF.
Note: Be sure to switch on the power to your mixer before switching
on the amplification system.
12. MASTER VU Meter
:
This VU meter shows the signal level of the mixer Master output.
13. MASTER EQUALIZER
The 3-band equalizers that allow the user to adjust the frequency
response of the Master bus signal respectively. The equalizers provide
a maximum 12dB of cut/boost for each frequency.
14. PHONO/CD Inputs:
Plug your turntables or line device in here. Select the PHONO/CD
switch to the desired input.
15. LINE/CD Inputs:
These inputs are unbalanced RCA jacks, connect stereo audio from Hi
Fi VCRs, cassette and reel-to-reel tape decks, CD players, VDPs,
Tuners, even synthesizers or other mixing consoles.
16. PHONO/ CD Switch:
The push button switches beside channel 1and 3 inputs change the
input type from Phono to CD.
17. GND:
The GND is a terminal for grounding turntables to eliminate hum.
18. Record Outputs:
This outputs is used for additional feed to such items of equipment as
tape records. The output level of the signal is not affected by the
Master Level control.
19. Unbalanced Master Outputs:
These stereo outputs are low impedance, unbalanced RCA jacks
controlled by the Master Level.
20. MAINS Connection:
A standard IEC AC power socket for connecting to the main AC supply.
Before you connect your Mixer to the mains, please make sure that
your local voltage matches the voltage required by the unit!
21. FUSE Holder:
The IEC power socket has an integral fuse holder that takes a 20mm
fuse. Always replace a blown fuse with the same type as specified on
the rear of the Mixer.
8
SPECIFICATIONS
Input Sensitivity/ Impedance:
DJ MIC 3mV / 1KOhms
PHONO 3mV / 51KOhms (RIAA)
CD/LINE 150mV / 100KOhms
Output Level/ Impedance:
MASTER (Max. Output: 8V) 775mV/600Ohms Unbalanced
REC (Max. Output: 8V) 380mV/600Ohms
PHONES (Max. Output: 420mV) 380mV/8Ohms
Frequency Response: 20Hz~20KHz ±0.5dB
(RIAA ±2dB)
Total Harmonic Distortion: 0.01% (Rated output)
Stereo Separation: More than 45dB
Signal-To-Noise Ratio:
DJ MIC 80dB
PHONO 70dB
CD/LINE 85dB
Tone Control:
Boost/Cut@Center Frequency ±12dB@100Hz, 1K, 10KHz
Dimensions: 310mm* 236mm* 107mm
Weight 3.4kg
CAUTION: The apparatus shall not be exposed to dripping or splashing and
that no objects filled with liquids, such as vases, shall be placed
on the apparatus.
-866-
/