Wolf CHALLENGER CHR-6-0 Quick Manual

Category
Cookers
Type
Quick Manual
Item #_____________ C.S.I. Section 11420
Wolf Range Company, LLC
19600 S. Alameda St., Compton, CA 90221-6291
P.O. Box 7050, Compton, CA 90240-7050
(310) 637-3737 FAX (310) 637-7931 (800) 366-WOLF
Customer Service (888) 639-9653 www.WOLFRANGE.com
F-39052 (3/03)
MODEL: CHALLENGER SERIES
34" Skeleton Base Range
Approved by ______________________
Date: _____________________________
SPECIFY TYPE OF GAS AND FINISH WHEN ORDERING.
SPECIFY ALTITUDE WHEN ABOVE 2,000 FT.
Model CHR-6-0 shown
with optional casters
Design Certified by the American Gas Association
Design Certified by the Canadian Gas Association
Listed by the National Sanitation Foundation
CHALLENGER SERIES
34" SKELETON BASE RANGE
BASIC MODELS:
CHR-6-0 34" wide skeleton base range
CHR-4-0-FT11 34" wide skeleton base range
CHR-4-0-FT11B 34" wide skeleton base range
CHR-2-0-FT22 34" wide skeleton base range
CHR-0-0-FT34 34" wide skeleton base range
KEY FEATURES:
Front, back riser and high shelf finished in stainless steel.
Stainless steel bullnose, front manifold cover and 6"
adjustable legs.
Painted sides.
Six 26,000 BTU/hr. open burners with lift-off heads.
Pilot ignition system for automatic burner lighting.
Six heavy-duty cast iron top grates measure 11
1
8"w x
12
3
4"d.
Full width pull out crumb tray.
3
4" rear gas connection and gas pressure regulator.
One year limited parts and labor warranty.
OPTIONAL FEATURES:
Stainless steel side(s).
Stainless steel doors.
4
1
2" stainless steel stub back.
Stainless steel intermediate shelf.
Set of four casters (two locking).
DESCRIPTION:
34" wide medium duty gas restaurant range with open storage
base, Wolf Model No. CHR-6-0. Front, riser and high shelf
finished in stainless steel. Stainless steel bullnose, front mani-
fold cover and 6" adjustable legs. Six 26,000 BTU/hr. top
burners with lift-off heads. Pilot ignition system for automatic
burner lighting. Six heavy cast iron top grates measure
11
1
8"w x 12
3
4"d. Full width pull out crumb tray located beneath
burners. Total input 156,000 BTU/hr.
Exterior dimensions:
33
5
8"w x 32
3
4"d x 57
1
2"h on 6" adjustable legs.
37" working height.
NOTE: In line with its policy to continually improve its product, Wolf Range Company
reserves the right to change materials and specifications without notice.
This appliance is manufactured for commercial use only and is not intended for home use.
F-39052 (3/03)
Challenger Series
34" Skeleton Base Range
INSTALLATION REQUIREMENTS:
1. A pressure regulator sized for this unit is included. Natural
gas 5.0" W.C., propane gas 10.0" W.C.
2. Gas line connecting to range must be
3
4" or larger. If flexible
connectors are used, the inside diameter must be the same
as the
3
4" iron pipe.
3. An adequate ventilation system is required for commercial
cooking equipment. Information may be obtained by writing
to the National Fire Protection Association, 1 Batterymarch
Park, Quincy, MA 02269, www.NFPA.org. When writing,
refer to NFPA No. 96.
4. These units are manufactured for installation in accordance
with ANSZ223.1A (latest edition), National Fuel Gas Code.
Copies may be obtained from The American Gas Associa-
tion, 400 N Capitol St. NW, Washington, DC 20001,
www.AGA.org.
5. Clearances: Combustible Non-combustible
Rear 2" 0"
Sides 10" 0"
6. For proper combustion, install equipment on adjustable legs
or casters provided with unit. On curb or platform, allow
3
1
2" front overhang (see adjacent diagram). Leveling bolts
are required for curb installation. Specify when ordering.
TOP OPTIONS:
11", 22" and 34" wide griddle tops in 1" thickness. 20,000
BTU/hr. input per 11" griddle width. Choice of manual or
thermostatic controls, one control per burner. Spatula width
front grease trough.
11
1
8" x 25
1
2" hot top in place of two open burners, 22,000
BTU/hr. input.
CHR-6-0 CHR-4-0-FT11 CHR-4-0-FT11B
CHR-2-0-FT22 CHR-0-0-FT34
  • Page 1 1
  • Page 2 2

Wolf CHALLENGER CHR-6-0 Quick Manual

Category
Cookers
Type
Quick Manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI