Fakir HL30 Owner's manual

Brand: Fakir

Model: HL30

Category: Space heaters

Type: Owner's manual

This manual is also suitable for

HL 30

Gebrauchsanleitung

Instructions for use

Mode d´emploi

Instrucciones de uso

Heizlüfter

Fan heater

Radiateur soufflant

Termoventilador

HL 30

Prestige

Page is loading ...

Informationen für Ihr Sicherheit und Entsorgungshinweise Seite 4-5

Technische Daten Seite 5

Mindestabstände Seite 6

Wandmontage Seite 6

Inbetriebnahme Seite 7

Nach dem Gebrauch, Entsorgung Seite 20

Wenn Sie mal nicht weiterkommen ... Seite 21

Garantie Seite 22

Informations for your safety and notes on disposal page 8-9

Technical data page 9

Minimum distances page 10

Wall mounting page 10

Operation and use page 11

Informations pour votre sécurité et remarques d’ordre général page 12-13

Dates techniques page 13

Distances minima

page 14

Fixation murale page 14

Mise en service page 15

Informaciones para su seguridad e instrucciones para la eliminación

del aparato desechado Pág. 16-17

Datos técnicos Pág. 17

Distancias minimas Pág. 18

Fijación a la pared Pág. 18

Puesta en funcionamiento Pág. 19

Inhaltsverzeichnis

Table of contents

Tables des matiéres

Indice

Page is loading ...

Before using the appliance

• Please read the information below with care. This gives important guidance on the

use, safety and maintenance/care of the appliance. Keep this instruction booklet in a

safe place, and if appropriate, pass it on to the next owner.

• Fakir appliances comply with the recognised technological standards and current

safety regulations for electrical appliances and products (GPSG).

• This appliance fulfills the requirements of the Appliance and Product Safety Law

(GPSG) and the EU Directives 2004/108/EC “Electromagnetic Compatibility” and

2006/95/EC “Low-Voltage Directive.”

• Fakir reserves the right to alter designs and specifications without notice.

Intended purpose

• For private and commercially used apartments and adjoining rooms.

• The fan heater is excellent to provide additional heating: it should not be considered

as a centralized central heating unit.

General instructions

• Do not connect the appliance to the mains power socket if the voltage given on the

rating plate differs from the mains voltage.

• The power socket must be protected by a domestic 16 A automatic circuit-breaker.

• Do not use the appliance in case of any evidence of damag (cracks / fractures), if the

connecting lead is defective, or if internal damage is suspected (e.g. after being drop-

ped).

• Appliance surface can get heated up over 60°C.

• Appliance is not suitable for connection to fixed wiring systems.

• The appliance should not be placed or mounted directly below a wall mains socket.

• The appliance may only be opened by a qualified technician (e.g. Fakir customer ser-

vice).

• Heating appliances, which have not been used for a long period of time, need to be

checked by a qualified technician (e.g. Fakir customer service) before being used

again or before each new heating period. This especially applies if the appliance is soi-

led inside.

• The power supply cord has to be replaced by an authorized Fakir After Sales Service

only.

• Repair and maintenance work may only be performed by qualified technicians (e.g.

Fakir customer service). Only original Fakir spare parts may be used. Improperly repai-

red or serviced appliances pose a threat to the user.

• Fakir will not accept any liability for damage or injury if the appliance is used other than

for its intended purpose or is improperly operated or inexpertly repaired and maintai-

ned.

Safety precautions

• This appliance must not be used in any kind of vehicle (lifts, motor vehicles, cars, cable

cars, etc.).

For vehicle safety reasons the appliance may not be installed or operated in vehicles

because appliances like these require special components (such as e.g. protected

heating elements, more powerful motors, reinforced component attachments to protect

Information for safety and notes on disposal

against vibration etc.).

• Caution: Never use the appliance in the bathtub, shower, washbasin or pool.

• When the appliance is placed in position or mounted to a wall, please observe the

safety clearances as outlined in the sketches on page 10 !

• Put or install the appliance so that the switch and other control and operating units can-

not be touched by the user of bathtub, shower, washbasin or pool.

• Appliance must not be covered with towels, curtains or similar items because cover-

ing up might cause overheating.

• This appliance is not designed to be used by persons (including children) with limited

physical, sensory or mental capacities or by persons lacking in experience and/or kno-

wledge, unless they are supervised by someone who is responsible for their safety or

have received instructions on how to use the appliance. Children should be supervi-

sed to ensure that they do not play with the appliance.

• Children cannot always recognize the dangers of using electrical equipment, so never

leave them unsupervised when using the heater !

• When operating the appliance, the cable should be fully extended or unwound from

the cable compartment.

• The power supply cord must not lie on the appliance when in use.

• Do not pull out the plug from the power supply socket by pulling on the power supply

cord.

• Do not pull the power supply cord over sharp edges or allow it to become jammed.

• Do not use damaged extension leads.

• Do not store the appliance in the open air or in the car or permit it to be exposed to

any other source of heat.

• Pull out the plug from the power supply socket before cleaning the appliance and use

only a dry or slightly moist cloth.

• Clean the appliance only with a dry or slightliy moist cloth.

• After use, please disconnect appliance, pull out mains plug, let appliance cool down

and wind up cable. Please store appliance protected from dust.

Disposal instructions

• Please dispose of the packaging materials and, eventually, the appliance itself in

accordance with the official regulations or guidelines which apply.

• If facilities are available in your locality for the recycling of packaging materials, plea-

se make use of these accordingly.

• When finally disposing of the appliance itself, please render it unserviceable before

taking it to the authorized place of disposal.

Technical data

Voltage 230 V / 50 Hz

Power 2000 W max.

Safety system IPX 1

Safety class II

Dimension (WxHxD) 25 x 34 x 9 cm

Information for safety and notes on disposal

If you want to mount the fan heater on the wall

• Select a spot near a socket, but not directly underneath it,

and ensure the minimum distances from the wall and from

the ceiling and/or floor.

• To fit the wall holder, hold it against the wall at the inten-

ded spot like drawing A, and mark the positions of the

fastening holes with a sharp pencil.

• Ensure that the holder is horizontal and that the holes are

clear of electric cables and pipes.

• Drill the holes at the marked points and insert plastic

pougs. Then screw the wall holder in tight.

• Insert the two distance holders (a) according sketch B on

the left and right side of the rear and push the base sup-

port (b) after pressing the locking device (c) until it stops.

• Slide the fan heater (while holding it vertical) into the wall

holder by its rear face and fix it with the screw according

sketch C.

Caution: When fitting the base as the wall holder, ensure

that no curtains, towels or other inflammable objects can

be hung in front of the fan heater later on. This could

cause overheating.

Wall mounting

Minimum distances ...

Do not mount within the depicted

areas !

... to neighbouring objects, walls and

ceilings

30 cm

Stand the heater at the required location:

• Pull-out the base support until it snaps audibly into place.

• Unwind the supply cable completely and insert the plug into a power supply socket.

Switch on the fan heater at the function selector [D]:

Pos. 0 OFF

Pos. I 1000 watt heating > indicator [1] lights

Pos. II 2000 watt heating > indicator [2] lights additionally

Pos.  frost gard setting

Room thermostat [E]

The temperature setting is continuously variable with the thermostat control.

Setting:

max. temperature = turn clockwise

min. temperature = turn anti-clockwise

Turn the thermostat control all the way to the right (clockwise). When the desired room

temperature has been reached, turn knob anti-clockwise until the heater is switched off.

The heater automatically switches on again as the room temperature declines.

Frost guard setting 

Turn the knob to the frost guard setting so that the room temperature will not drop below

approx. +5°C ( for instance when absent for an extended period ). The appliance will then

automatically switch itself on at approx. +5°C, and off at +7°C, thereby preventing frost

damage.

Overheat safety cut-out

An overheat safety cut-out turns off the appliance in the event of a technical fault or if the

heater is not being used properly.

If the cut-out has been activated, then turn the selector switch knob to the “0” setting, dis-

connect the heater from the mains, and remedy the fault or ensure that the heater is being

properly used.

The overheat safety cut-out is reactivated after a short cooling down period, and the hea-

ter can once again be operated. Otherwise the appliance has to be checked by a Fakir

after-sales-service.

NOTE:

Always ensure that there is adequate minimum distances. The outflowing air

must not be obstructed by any object.

Operation and use

Page is loading ...

Fakir HL30 Owner's manual

Brand: Fakir

Model: HL30

Category: Space heaters

Type: Owner's manual

This manual is also suitable for

HL 30

Download PDF

report

in other languages

français: Fakir HL30 Le manuel du propriétaire
español: Fakir HL30 El manual del propietario
Deutsch: Fakir HL30 Bedienungsanleitung

Fakir HL30 Owner's manual

This manual is also suitable for

Fakir HL30 Owner's manual

in other languages

Related papers

Other documents