GE 169134 User manual

Category
Irons
Type
User manual
840165700
106671R, 169153, 106822R, 106820,
169133, 169134, 169159
IRON
FER À REPASSER
PLANCHA
g
READ BEFORE USE
LIRE AVANT L’UTILISATION
LEA ANTES DE USAR
For Customer Assistance, call Customer Service at
1-877-207-0923 (US) or 1-877-556-0973 (Canada)
Pour l’assistance à la clientèle au Canada : 1-877-556-0973
Para comunicarse con Asistencia al Cliente en México: 01-800-343-7378
Le invitamos a leer cuidadosamente este instructivo antes de usar su aparato.
840165700 Ev02 5/1/07 4:05 PM Page 1
When using your flatiron, basic safety precautions should always be followed, including
the following:
This product is intended for household use only.
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric
shock, this plug is intended to fit into a polarized outlet only one way. If the plug does not fit fully into
the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to
modify the plug in any way.
Use the iron on an ironing board. Ironing on any other surface may damage that surface.
Do not iron or vertical steam clothes that are being worn.
Do not use vertical steam in the direction of people or pets.
READ ALL INSTRUCTIONS BEFORE USING
1. Use iron only for its intended use.
2. To protect against risk of electric shock, do not immerse the iron in water or other liquids.
3. The iron should always be turned to OFF ( O ) before plugging or unplugging from outlet. Never
yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.
4. Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. Fully
retract cord within unit or loop cord loosely around iron, as applicable, when storing.
5. Always disconnect iron from electrical outlet when filling with water or emptying and when not
in use.
6. Do not operate iron with a damaged cord or if the iron has been dropped or damaged.
To avoid the risk of electric shock, do not disassemble the iron. Call our toll-free customer assis-
tance number for information on examination and repair. Incorrect reassembly can cause a
risk of electric shock when the iron is used.
7. Close supervision is necessary for any appliance being used by or near children. Do not leave
iron unattended while connected or on an ironing board.
8. Burns can occur from touching hot metal parts, hot water, or steam. Use caution when you
turn a steam iron upside down there may be hot water in the reservoir.
SPECIAL INSTRUCTIONS
1.
To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
2. If an extension cord is absolutely necessary, a 10-ampere cord should be used. Cords rated for
less amperage may overheat. Care should be taken to arrange the cord so that it cannot be
pulled or tripped over.
2
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS!
OTHER CONSUMER SAFETY INFORMATION
840165700 Ev02 5/1/07 4:05 PM Page 2
3
• Steam vents should be cleaned before first use.
• During the first use of the iron, it may appear to smoke. This will stop and does not
indicate a defect or hazard.
• To clean steam vents before first use, prepare iron for steam ironing, then iron over
an old cloth for a few minutes while letting the iron steam. Press the Blast button
several times to clean the vents. Then follow the Self-Cleaning instructions.
• Many irons spit or sputter during the
first few uses with tap water. This happens
as the
steam chamber becomes conditioned. This will stop after a few uses.
Blast Spray
BEFORE FIRST USE
PARTS AND FEATURES
Adjustable Steam Switch
(see inset)
Water Tank Opening
Spray Nozzle
Water Window
Temperature Control Dial
Soleplate
Power ON/Auto
Shutoff Reset
Button/Light
Heel Rest
Spray/Blast Buttons
(see inset)
Cord
Spray/Blast Buttons
Adjustable Steam
Cord Release Button
(on select models)
Retractable Cord
(on select models)
840165700 Ev02 5/1/07 4:05 PM Page 3
4
1. Unplug iron. Turn Adjustable Steam Switch to Dry Iron O. Set iron upright on heel rest.
2. Using a cup, slowly pour tap water into water tank opening until MAX fill line has
been reached. Do not fill iron directly from the faucet.
3. Plug iron into outlet.
4. Turn
the Temperature
Control Dial to desired fabric setting in the steam range.
5. Allow two minutes for the iron to reach desired temperature.
6. Set Adjustable Steam Switch to the recommended steam level. See the “Fabric
Setting Chart.”
7. To turn iron off, set Adjustable Steam Switch to Dry Iron O. Turn the Temperature
Control Dial to OFF ( O). Unplug iron.
8. Empty water from the iron following directions in “Caring for Your Iron.”
Water
Please use ordinary tap water. If you have extremely hard water, alternate between
tap water and distilled water for use in the iron.
1. Plug iron into outlet.
2. Turn Adjustable Steam Switch to Dry Iron O.
3. Turn Temperature Control Dial to desired temperature. Allow two minutes for iron to
reach desired temperature.
4. To turn iron OFF (O), turn Temperature Control Dial to OFF (O) and unplug iron.
Ironing Instructions
Dry iron using spray if necessary.
Dry iron on the wrong side of the fabric.
Iron while fabric is still damp.
Use a press cloth and steam iron on the
wrong side of fabric.
Iron using spray if necessary.
For cotton, iron while still damp or use spray.
For linen, iron fabric on wrong side.
Temperature Setting
Off
Nylon,
Acrylic
Silk
Polyester
Wool
Rayon
Cotton,
Linen
Dry Iron
Steam Range
Steam
Setting
••
••
•••
•••
O
TO DRY IRON
TO STEAM IRON
FABRIC SETTING CHART
840165700 Ev02 5/1/07 4:05 PM Page 4
5
Iron
1. The water tank of your iron should be emptied after each use. Turn Temperature
Control Dial to OFF ( O ). Unplug the iron and hold over a sink. Slowly tilt pointed end
of iron down over sink. Water will run out of water tank opening.
2. After iron has completely cooled, fully retract cord into iron or loop cord loosely
around iron, as applicable, and store in an upright position. NOTICE: Do not store
iron laying flat on soleplate.
Soleplate
1. Never iron over zippers, pins, metal rivets, or snaps, as these may scratch the
soleplate.
2. To clean occasional build-up on the soleplate, wipe with a sudsy cloth. Do not use
abrasive cleansers or metal scouring pads.
3. Always store iron upright in the heel rest position.
Self-Clean (on selected models)
To keep the steam vents clear of any build-up, follow these instructions each time you
iron using steam.
1. Turn Temperature Control Dial to OFF ( O ) and set Adjustable Steam Switch to Dry
Iron O. Fill iron with water to
1
2 of its maximum capacity.
2. Turn Temperature Control Dial to Linen setting and let iron heat for 2 minutes. Keep
Adjustable Steam Switch on Dry Iron O.
3. Turn Temperature Control Dial to OFF ( O ). Unplug iron and hold over a sink with
soleplate facing down.
4. Turn Adjustable Steam Switch to MAX, while pressing Blast of Steam button often. Boiling
water and steam will flow out of steam vents. Allow all water to drain from iron.
5. Gently move iron front to back to allow water to clean entire soleplate area.
6. If water still remains inside of soleplate, reheat iron as indicated in Step 2. Boiling
water and steam could still flow out of steam vents.
CARING FOR YOUR IRON
840165700 Ev02 5/1/07 4:05 PM Page 5
6
Adjustable Steam Switch
This knob provides steam for fabrics such as wool and linen. See the “Fabric Setting
Chart” for details. Set the switch to Dry Iron O to iron without steam.
Spray and Blast of Steam Buttons
Push Blast Button for an extra blast of steam. Push Spray Button to release a fine spray
of water for difficult
wrinkles in cotton or linen.
Power ON/ Auto Shutoff Reset Button/Light
This light comes on when the iron is first plugged in. After one hour, the iron will shut
off and the light will go out. Push the Reset Button/Light to turn
the iron back on.
Power On Light
On units not provided with Auto Shutoff, this light comes on when the iron is plugged in
and remains on until the iron is unplugged. The light stays on even if Temperature
Control Dial is turned to OFF ( O ).
Retractable Cord
1. Pull cord to desired length. Do not unwind cord beyond colored tape indicator on
cord.
2. To store cord, press and hold the Cord Release Button while guiding the cord into the
storage area.
ww
WARNING: To reduce the risk of an eye injury, hold the
plug while retracting the cord.
FEATURES
(on selected models)
840165700 Ev02 5/1/07 4:05 PM Page 6
7
PROBLEM
Iron won’t heat.
Water is leaking
out of the iron.
Iron won’t steam.
Iron leaves spots
on clothing.
Wrinkles not
removed.
Fabric/clothing
scorched.
Twisted cord.
Retractable cord
will not unwind (on
select models).
Things TO CHECK
• Is the iron plugged in and the outlet working?
Check the outlet by plugging in a lamp.
• Is the Temperature Control Dial turned to a fabric setting?
• If auto shutoff model, is the Reset Light illuminated? If not,
push to reset.
• Do not overfill the water tank.
• If steam ironing, is Adjustable Steam Switch in a steam
position and the Temperature Control Dial in the steam
range? Did the iron have enough time to preheat?
• If dry ironing, make sure the Adjustable Steam Switch is in
the DRY IRON position.
• Check the water level.
• Is the Adjustable Steam Switch in the STEAM position?
• Has the iron had enough time to preheat?
• ALWAYS empty the water tank of the iron after using.
Water left in the tank may discolor clothing and soleplate.
• Check Temperature Control Dial is set to correct fabric.
• Check Temperature Control Dial and set to lower setting.
Allow iron to cool down 5 minutes before continuing.
If the iron cord should become twisted, turn iron OFF (O),
turn Control Dial to OFF (O) and unplug iron. Let cool. Empty
water from iron.Hold iron cord in the middle of entire length.
Let plug and iron dangle freely until cord uncoils. This will
extend the life of your iron cord.
Rewind a small amount of cord then fully depress the Cord
Release Button and pull the cord to desired length.
TROUBLESHOOTING
840165700 Ev02 5/1/07 4:05 PM Page 7
If you have a claim under this warranty, please call our Customer Assistance Number.
For faster service please have model, series, and type numbers ready for operator to
assist you. These numbers can be found on the bottom of your appliance.
MODEL: ________________ TYPE: _________________ SERIES: ________________
Customer Assistance Number 1-877-207-0923 (US) or 1-877-556-0973 (Canada)
Keep these numbers for future reference!
For more information, please visit us at www.walmart.com
Two-Year Limited Warranty
What does your warranty cover?
• Any defect in material or workmanship.
For how long after the original purchase?
• Two years.
What will we do?
• Provide you with a new one.
• For those items still under warranty but no
longer available, WAL-MART reserves the
right to replace with a similar GE branded
product of equal or greater value.
How do you make a warranty claim?
• Save your receipt.
• Properly pack your unit. We recommend
using the original carton and packing
materials.
• Return the product to your nearest
WAL-MART store or call Customer
Assistance at 1-877-207-0923 (US) or
1-877-556-0973 (Canada).
What does your warranty not cover?
• Parts subject to wear, including, without
limitation, glass parts, glass containers,
cutter/strainer, blades, seals, gaskets,
clutches, motor brushes, and/or agitators,
etc.
• Commercial use or any other use not found
in printed directions.
• Damage from misuse, abuse, or neglect,
including failure to clean product regularly
in accordance with manufacturer’s
instructions.
How does state law relate to this warranty?
• This warranty gives you specific legal
rights, and you may also have other rights
which vary from state to state or province
to province.
• THIS WARRANTY IS IN LIEU OF ANY OTHER
WARRANTY OR CONDITION, WHETHER
EXPRESS OR IMPLIED, WRITTEN OR ORAL,
INCLUDING, WITHOUT LIMITATION, ANY
STATUTORY WARRANTY OR CONDITION OF
MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE.
• WAL-MART, GE, AND THE PRODUCT
MANUFACTURER EXPRESSLY DISCLAIM ALL
RESPONSIBILITY FOR SPECIAL, INCIDENTAL,
AND CONSEQUENTIAL DAMAGES OR LOSSES
CAUSED BY USE OF THIS APPLIANCE. ANY
LIABILITY IS EXPRESSLY LIMITED TO AN
AMOUNT EQUAL TO THE PURCHASE PRICE
PAID WHETHER A CLAIM, HOWEVER
INSTITUTED, IS BASED ON CONTRACT,
INDEMNITY, WARRANTY, TORT (INCLUDING
NEGLIGENCE), STRICT LIABILITY, OR OTHER-
WISE. SOME STATES OR PROVINCES DO NOT
ALLOW THIS EXCLUSION OR LIMITATION OF
INCIDENTAL OR CONSEQUENTIAL LOSSES
SO THE FOREGOING DISCLAIMER MAY NOT
APPLY TO YOU.
What if you encounter a problem with this
product while using it outside the country
of purchase?
• The warranty is valid only in the country of
purchase and you follow the warranty
claim procedure as noted.
CUSTOMER SERVICE
is a trademark of General Electric Company
and is used under license by
WAL-MART Stores, Inc., Bentonville, AR 72716
g
Marketed in Canada by:
Wal-Mart Canada Corp.
1940 Argentia Road, Mississauga, Ontario L5N 1P9
840165700 Ev02 5/1/07 4:05 PM Page 8
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

GE 169134 User manual

Category
Irons
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI