2. Schoolhouse
  3. Bureau Rack

Schoolhouse Bureau Rack Operating instructions

  • Hello! I've read the user manual for the SCHOOLHOUSE Bureau Rack, which provides instructions for both the 3-hook and 5-hook versions. The document details the steps for mounting the rack on different types of walls, including stud and non-stud locations, and lists the necessary tools and hardware required for installation. I'm ready to answer any questions you have about installing or using the Bureau Rack.
  • What tools are required for installation?
    What hardware is included with the Bureau Rack?
    What are the different sizes available for the Bureau Rack?
Bureau Rack
schoolhouse.com
NOTES:
Instructions included for 3 hook and 5 hook
Bureau Racks.
REQUIRED TOOLS:
Electric Drill
1/
8" Drill Bit for Stud Installation
1/
2" Drill Bit for Non-stud Installation
Phillips Head Screwdriver
Level
Tape Measure
INCLUDED HARDWARE:
INSTALLATION INSTRUCTIONS
1. Hold Bureau Rack against wall in mounting location.
Check Level and mark top corners of Bureau Rack,
points A and B in drawing.
2. Using level, measure 2" below points A and B, mark
points C and D.
1
#10-24 x 1.75" Machine
Screw (x2)
Zip Toggle (x2)
#8 x 1.75" Wood
Screw (x2)
3. Using level, measure 2" in from C and D, mark
Keyhole Mounting Locations E and F. Make sure the
line between points E and F is level, and the distance is
precisely as listed in drawing.
A
C
3 Hook: 20.75"
5 Hook: 36.75"
E F
B
D
052918
schoolhouse.com
2
Lock
Ring
Metal
Wing
Zipper
Metal
Wing
Zipper Lock Ring
Non-stud Location
Stud Location
4. Determine wall substrate behind points E and F.
For stud locations, proceed to Step 5. For non-stud
locations skip to Step 6.
5. For stud locations, drill through drywall and stud at
points E and F using 1/8" Drill Bit.
6. For non-stud locations, drill through drywall at points
E and F using 1/2" Drill Bit.
7. Push Metal Wing end of Zip Toggle through drywall
while holding Zipper end of Zip Toggle.
8. When Metal Wing flips back into open position, push
Lock Ring up tight against wall and separate Zipper
halves. Zippers will break o at lock ring.
9. Depending on wall substrate, thread Wood Screws
into pre-drilled holes and/or Machine Screw into Lock
Rings. Tighten with Phillips Head Screwdriver leaving
screwheads 1/4" from wall.
10. Align Keyhole with Screws and slide Bureau Rack
down to mount. If loose, remove from wall and tighten
Screws. Install Bureau Rack again to check fit. Repeat
as necessary.
/