Quanum HB5808 Operating instructions

Operation Manual

Type：HB5808

I Product Working Scheme

Ⅱ①Instruction of Buttons:

1.The middle button-Confirm Button(Long press for 2 seconds to save the current setting )

2.Page Up-Select the menu

3.Page Down-Select the menu

②After the product is powered on ,please correct the receiving signal amplitude of A and B modules. As

follows:

Press Confirm Button one time (needs to press 2 times when display locking interface), to select the main page.

Press Page Down to select the fifth selection SETUP MENU to set the menu, press Confirm Button again to enter

the submenu SETUP MENU, press PAGE DOWN to select the third one: CALIBRATE RSSI. Correct the signal

amplitude of RISS, press Confirm Button to enter automatically check status. In the process of checking, press

Page Up to correct again. After correcting, the current channel will be set to enter the CALIBRATE RSSI mode.

(Attention: It’s better to open 5.8G AV transmission system when checking.)

Antenna

Connector

B Receiver Module

Ribbon Wire Connector

USB

Power Supply/Application

Upgrade Connector

OLCD Display

Confirm Button

Page Up

Page Down

Operating Light

Receiver Module Indicator

ⅢIntroduction of Main Interface：

E 8 ： Channel E 8CH Channels Included：A-B-E-F-C Each

channel has 1-8 channels.

5945 ：Channel frequency instructions: 5645-5945MHZ

<Shi Jie> : (Characters｜Symbols）Logo, can change in the menu

settings.

AUTO: Automatic mode, channel locked, no operation in 6 seconds will enter the main interface

automatically, preview interface displays the current band, frequency, user name and diversity state. Auto shows

Download PDF